FireCADCalc

Material Removal Rate: Turning, Milling, Drilling

Material removal rate for turning (speed × feed × depth), milling (width × depth × table feed) and drilling (hole area × feed × rpm).

Inputs

Examples: TurningMilling, table feed 30 mm/sDrilling 12 mm

Turning and drilling: mm per revolution. Milling: enter the table feed per second here in mm.

Results

Material removal rate216.00cm³/min

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Turning. The inputs, in the units selected above:

InputValue
ProcessTurning
Cutting speed (turning)180.00 m/min
Feed per revolution (turning, drilling)0.25000 mm
Depth of cut2.0000 mm
Width of cut (milling)30.000 mm
Drill diameter12.000 mm
Table feed (milling)15.000 mm/min
Spindle speed (drilling)800.00 rpm

Applying the formula below gives:

ResultValue
Material removal rate90.000 cm³/min

Open this example in the calculator and change any input.

Formula

\(Q = v_c f a_p, \quad Q = a_e a_p v_f\ (v_f\ \text{table feed}), \quad Q = \frac{\pi D^2}{4} f N\)

Variables

Symbol Meaning SI unit
\(\text{process}\) Process -
\(v_c\) Cutting speed (turning) m/s
\(f\) Feed per revolution (turning, drilling) m
\(a_p\) Depth of cut m
\(a_e\) Width of cut (milling) m
\(D\) Drill diameter m
\(v_f\) Table feed (milling) m/s
\(N\) Spindle speed (drilling) 1/s
\(Q\) Material removal rate m³/s

Method and standards

Kinematics.

Where it is used

  • Machining time and power estimates.
  • Process planning.

Common mistakes

  • Feed per tooth used as table feed.
  • Units mixed.

Assumptions and limits

  • Steady cutting. The milling table feed is a speed (shown in mm/min), separate from the feed per revolution.

References

  • MRR = v f a_p (turning); a_e a_p v_f (milling); (πD²/4) f N (drilling) (Kalpakjian, Manufacturing Engineering and Technology)

Questions and answers

Turning at 180 m/min, 0.25 mm/rev, 2 mm deep?

90 cm³/min.

Why does MRR matter?

Power, time and cost all follow from it.

Milling table feed?

Feed per tooth × teeth × rpm; see the milling feed calculator.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.