Worked example
Example: Turning. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Process | Turning |
| Cutting speed (turning) | 180.00 m/min |
| Feed per revolution (turning, drilling) | 0.25000 mm |
| Depth of cut | 2.0000 mm |
| Width of cut (milling) | 30.000 mm |
| Drill diameter | 12.000 mm |
| Table feed (milling) | 15.000 mm/min |
| Spindle speed (drilling) | 800.00 rpm |
Applying the formula below gives:
| Result | Value |
|---|---|
| Material removal rate | 90.000 cm³/min |
Open this example in the calculator and change any input.
Formula
\(Q = v_c f a_p, \quad Q = a_e a_p v_f\ (v_f\ \text{table feed}), \quad Q = \frac{\pi D^2}{4} f N\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(\text{process}\) | Process | - |
| \(v_c\) | Cutting speed (turning) | m/s |
| \(f\) | Feed per revolution (turning, drilling) | m |
| \(a_p\) | Depth of cut | m |
| \(a_e\) | Width of cut (milling) | m |
| \(D\) | Drill diameter | m |
| \(v_f\) | Table feed (milling) | m/s |
| \(N\) | Spindle speed (drilling) | 1/s |
| \(Q\) | Material removal rate | m³/s |
Method and standards
Kinematics.
Where it is used
- Machining time and power estimates.
- Process planning.
Common mistakes
- Feed per tooth used as table feed.
- Units mixed.
Assumptions and limits
- Steady cutting. The milling table feed is a speed (shown in mm/min), separate from the feed per revolution.
References
- MRR = v f a_p (turning); a_e a_p v_f (milling); (πD²/4) f N (drilling) (Kalpakjian, Manufacturing Engineering and Technology)
Questions and answers
Turning at 180 m/min, 0.25 mm/rev, 2 mm deep?
90 cm³/min.
Why does MRR matter?
Power, time and cost all follow from it.
Milling table feed?
Feed per tooth × teeth × rpm; see the milling feed calculator.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.