FireCADCalc

Extrusion Pressure and Force (Ideal and Johnson)

Extrusion pressure and ram force from the extrusion ratio and mean flow stress, as ideal work and by Johnson's empirical form with your constants.

Inputs

Examples: Hot aluminium 100 to 30 mmCopper 150 to 50 mm

From your process data or a forming text; the default pair (0.8, 1.5) is illustrative only.
From your process data or a forming text; the default pair (0.8, 1.5) is illustrative only.

Results

Billet-container friction in direct extrusion adds more at the start of the stroke.

Extrusion ratio A₀/A_f11.111
Ideal pressure σ̄ ln R120.40MPa
Johnson pressure σ̄(a + b ln R)220.60MPa
Ram force (Johnson)1,732.6kN

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Hot aluminium 100 to 30 mm. The inputs, in the units selected above:

InputValue
Billet diameter100.00 mm
Extrudate diameter (equivalent)30.000 mm
Mean flow stress50.000 MPa
Johnson constant a0.80000 -
Johnson constant b1.5000 -

Applying the formula below gives:

ResultValue
Extrusion ratio A₀/A_f11.111
Ideal pressure σ̄ ln R120.40 MPa
Johnson pressure σ̄(a + b ln R)220.60 MPa
Ram force (Johnson)1,732.6 kN

Open this example in the calculator and change any input.

Formula

\(R = \frac{A_0}{A_f}, \quad p = \bar\sigma(a + b\ln R), \quad F = p A_0\)

Variables

Symbol Meaning SI unit
\(D_0\) Billet diameter m
\(D_f\) Extrudate diameter (equivalent) m
\(\bar\sigma\) Mean flow stress Pa
\(a\) Johnson constant a -
\(b\) Johnson constant b -
\(R\) Extrusion ratio A₀/A_f -
\(p_i\) Ideal pressure σ̄ ln R Pa
\(p\) Johnson pressure σ̄(a + b ln R) Pa
\(F\) Ram force (Johnson) N

Method and standards

Ideal work plus empirical terms.

Where it is used

  • Extrusion press sizing.
  • Examinations.

Common mistakes

  • Diameter ratio for area ratio.
  • Cold flow stress for hot work.

Assumptions and limits

  • Steady extrusion.
  • The Johnson constants a and b depend on the process and die; the defaults are illustrative, not a sourced pair: take yours from process data or a forming text.

References

  • Ideal p = σ̄ ln R; Johnson p = σ̄(a + b ln R) (Kalpakjian; Johnson and Mellor)

Questions and answers

100 mm billet to 30 mm at 50 MPa (hot aluminium)?

R 11.1; Johnson pressure 221 MPa, force 1.73 MN.

Why the empirical form?

It adds friction and redundant work to the ideal value.

Shapes?

Use the area of the profile for A_f (equivalent diameter).

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.