FireCADCalc

Laser, Plasma or Waterjet Cutting Time

Cutting time for a profile-cut part from total cut length, cutting speed, number of pierces and pierce time, with rapid moves, and the cost at a machine rate.

Inputs

Examples: Laser 6 m of cutPlasma 20 mm plate

From the machine's cutting chart for the material and thickness.

Results

Chart speeds are for straight cuts: corners, small holes and short contours slow the head, so the real time is longer. Allow for it, or use the machine's nesting software.

Total time2.3667min
Cost118.33

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Laser 6 m of cut. The inputs, in the units selected above:

InputValue
Total cut length6.0000 m
Cutting speed3.0000 m/min
Number of pierces12.000 -
Time per pierce1.5000 s
Rapid travel length4.0000 m
Rapid speed60.000 m/min
Machine rate per hour3,000.0 -

Applying the formula below gives:

ResultValue
Total time2.3667 min
Cost118.33

Open this example in the calculator and change any input.

Formula

\(t = \frac{L}{v} + n_p t_p + \frac{L_r}{v_r}, \quad C = \frac{t\,c}{3600\ \mathrm{s/h}}\)

Variables

Symbol Meaning SI unit
\(L\) Total cut length m
\(v\) Cutting speed m/s
\(n_p\) Number of pierces -
\(t_p\) Time per pierce s
\(L_r\) Rapid travel length m
\(v_r\) Rapid speed m/s
\(c\) Machine rate per hour -
\(t\) Total time s
\(C\) Cost -

Method and standards

Time sum.

Where it is used

  • Fabrication quotes.
  • Nesting decisions.

Common mistakes

  • Chart speed on small contours.
  • Ignoring pierces.

Assumptions and limits

  • Constant speeds: no acceleration or slow-down on corners and small contours (a note reminds of this).

References

  • t = L/v + n_p t_p + L_r/v_r

Questions and answers

6 m of cut at 3 m/min, 12 pierces of 1.5 s, 4 m of rapids?

About 2.37 min: 118 at 3000 per hour.

Thick plate?

Pierce time rises steeply; plan fewer pierces with common-line cutting.

Acceleration?

Small features cut below the chart speed; add a margin.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.