FireCADCalc

Pattern Size with Casting Shrinkage and Machining Allowance

Pattern dimension from the finished casting dimension with the metal's shrinkage allowance and machining allowance per face.

Inputs

Examples: Grey iron 400 mm, both faces machinedSteel 250 mm, one face

Your foundry's figure: about 1 % for grey iron, 2 % for steel, 1.3 % for aluminium.

Results

Add draft angles separately; hindered contraction may need less shrinkage allowance.

Casting dimension (as cast)255.00mm
Pattern dimension260.10mm

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Grey iron 400 mm, both faces machined. The inputs, in the units selected above:

InputValue
Finished dimension400.00 mm
Shrinkage allowance1.0000 %
Machining allowance per face3.0000 mm
Machined faces on this dimension2.0000 -

Applying the formula below gives:

ResultValue
Casting dimension (as cast)406.00 mm
Pattern dimension410.06 mm

Open this example in the calculator and change any input.

Formula

\(L_c = L + n_f m, \quad L_p = L_c(1 + s)\)

Variables

Symbol Meaning SI unit
\(L\) Finished dimension m
\(s\) Shrinkage allowance -
\(m\) Machining allowance per face m
\(n_f\) Machined faces on this dimension -
\(L_c\) Casting dimension (as cast) m
\(L_p\) Pattern dimension m

Method and standards

Allowances.

Where it is used

  • Pattern making.
  • Pump casings and valve bodies.

Common mistakes

  • Applying shrinkage before machining allowance.
  • Same shrinkage for every alloy.

Assumptions and limits

  • Free contraction.
  • Outside dimensions only (machining adds material).
  • Shrinkage applied as L_p = L_c(1 + s); some foundries use L_c/(1 − s), which differs by about s² (0.04 % at 2 %).

References

  • Pattern = (finished + machining) × (1 + shrinkage) (foundry practice)

Questions and answers

400 mm machined both faces with 3 mm each, grey iron 1 %?

Cast 406 mm, pattern 410.06 mm.

Why does steel shrink more?

Larger contraction from solidus to room temperature.

Inside dimensions?

Machining enlarges a cored hole, so its cast size is the finished size less the allowances. This tool handles outside dimensions; for a hole work L_c = L − n_f m by hand, then multiply by (1 + s).

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.