FireCADCalc

Blanking and Piercing Force and Press Tonnage

Force to blank or pierce sheet from the cut perimeter, thickness and shear strength, with stripping force and press tonnage with a margin.

Inputs

Examples: 400 mm in 2 mm steelStainless washer

About 0.7–0.8 of the tensile strength for steel; your data.

Results

Shear on the punch (angled shear) cuts the peak force; die clearance per your tooling standard.

The stripping force acts on the return stroke and is not added to the press capacity; check the stripper springs or press return force for it.

Blanking force L t τ337.50kN
Stripping force27.000kN
Press capacity needed43.019tf

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 400 mm in 2 mm steel. The inputs, in the units selected above:

InputValue
Cut perimeter (all punches)0.40000 m
Sheet thickness2.0000 mm
Shear strength of the sheet320.00 MPa
Stripping force share10.000 %
Press capacity margin20.000 %

Applying the formula below gives:

ResultValue
Blanking force L t τ256.00 kN
Stripping force25.600 kN
Press capacity needed31.326 tf

Open this example in the calculator and change any input.

Formula

\(F = L\, t\, \tau_s\)

Variables

Symbol Meaning SI unit
\(L\) Cut perimeter (all punches) m
\(t\) Sheet thickness m
\(\tau_s\) Shear strength of the sheet Pa
\(k_s\) Stripping force share -
\(k_m\) Press capacity margin -
\(F\) Blanking force L t τ N
\(F_s\) Stripping force N
\(P\) Press capacity needed, F(1 + k_m) N

Method and standards

Shear.

Where it is used

  • Punch presses and tool rooms.
  • Gasket and plate cutting.

Common mistakes

  • Tensile strength for shear.
  • Forgetting multiple punches.

Assumptions and limits

  • Flat punch.
  • The stripping force acts on the return stroke and is not added to the press capacity, which is F(1 + k_m).
  • Press capacity is shown in tonne-force (kip in FPS).

References

  • F = L t τ_s (Kalpakjian; ASM Handbook vol. 14B)

Questions and answers

400 mm perimeter in 2 mm steel at 320 MPa?

256 kN: a 31 t press with 20 % margin.

Shear strength?

About 0.7–0.8 × tensile strength for steels.

Holes and blank together?

Add all perimeters cut in the stroke.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.