Worked example
Example: 400 mm in 2 mm steel. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Cut perimeter (all punches) | 0.40000 m |
| Sheet thickness | 2.0000 mm |
| Shear strength of the sheet | 320.00 MPa |
| Stripping force share | 10.000 % |
| Press capacity margin | 20.000 % |
Applying the formula below gives:
| Result | Value |
|---|---|
| Blanking force L t τ | 256.00 kN |
| Stripping force | 25.600 kN |
| Press capacity needed | 31.326 tf |
Open this example in the calculator and change any input.
Formula
\(F = L\, t\, \tau_s\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(L\) | Cut perimeter (all punches) | m |
| \(t\) | Sheet thickness | m |
| \(\tau_s\) | Shear strength of the sheet | Pa |
| \(k_s\) | Stripping force share | - |
| \(k_m\) | Press capacity margin | - |
| \(F\) | Blanking force L t τ | N |
| \(F_s\) | Stripping force | N |
| \(P\) | Press capacity needed, F(1 + k_m) | N |
Method and standards
Shear.
Where it is used
- Punch presses and tool rooms.
- Gasket and plate cutting.
Common mistakes
- Tensile strength for shear.
- Forgetting multiple punches.
Assumptions and limits
- Flat punch.
- The stripping force acts on the return stroke and is not added to the press capacity, which is F(1 + k_m).
- Press capacity is shown in tonne-force (kip in FPS).
References
- F = L t τ_s (Kalpakjian; ASM Handbook vol. 14B)
Questions and answers
400 mm perimeter in 2 mm steel at 320 MPa?
256 kN: a 31 t press with 20 % margin.
Shear strength?
About 0.7–0.8 × tensile strength for steels.
Holes and blank together?
Add all perimeters cut in the stroke.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.