FireCADCalc

Liquid–Liquid Extraction Stages (Kremser)

Theoretical stages of a counter-current extractor from the extraction factor KS/F, feed and raffinate concentrations and solute in the solvent (Perry's sec. 15).

Refinery and petrochemicalChemical and fertiliserPulp and paperFood, dairy and textile

Inputs

Examples: E = 2, 5 % to 0.2 %Recycled solvent with solute

Results

Extraction factor K S/F1.8000
Theoretical stages4.9955
Solute extracted96.667%

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: E = 2, 5 % to 0.2 %. The inputs, in the units selected above:

InputValue
Solute in the feed (solute-free ratio, kg per kg carrier)5.0000 %
Solute in the raffinate (solute-free ratio)0.20000 %
Solute in the entering solvent (solute-free ratio)0 %
Distribution ratio y/x2.5000 -
Solvent to feed ratio (solute-free basis)0.80000 -

Applying the formula below gives:

ResultValue
Extraction factor K S/F2.0000
Theoretical stages3.7004
Solute extracted96.000 %

Open this example in the calculator and change any input.

Formula

\(N = \frac{\ln\left[\frac{x_F - y_S/K}{x_R - y_S/K}\left(1 - \frac{1}{E}\right) + \frac{1}{E}\right]}{\ln E}, \quad E = \frac{KS}{F}\)

Variables

Symbol Meaning SI unit
\(x_F\) Solute in the feed -
\(x_R\) Solute in the raffinate -
\(y_S\) Solute in the entering solvent -
\(K\) Distribution ratio y/x -
\(S/F\) Solvent to feed ratio (solute-free basis) -
\(E\) Extraction factor K S/F -
\(N\) Theoretical stages -
\(\eta\) Solute extracted -

Method and standards

Kremser equation for extraction.

Where it is used

  • Solvent extraction design.
  • Checking mixer-settler trains.

Common mistakes

  • Using mass ratios with molar K.
  • Ignoring solvent solute.

Assumptions and limits

  • Dilute; immiscible solvents; constant K.
  • Concentrations are solute-free ratios X = x/(1 − x) (kg solute per kg carrier or solvent), consistent with S/F on a solute-free basis. Entering mass fractions instead is close only when dilute: at 5 % the difference is about 5 %.

References

  • Perry's Chemical Engineers' Handbook
  • 9th ed. (McGraw-Hill, 2019)
  • sec. 15 (liquid–liquid extraction): Kremser equation with the extraction factor

Questions and answers

What extraction factor is sensible?

1.3–2: below 1 the recovery is limited however many stages are used.

Why solute-free basis?

Kremser assumes constant solvent and feed flows, true for dilute solutions.

Is K constant?

Only for dilute systems; check against the equilibrium curve.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.