Worked example
Example: Air 5 kg/s, 1 → 4 bar. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Gas mass flow | 18,000 kg/h |
| Suction temperature | 35.000 °C |
| Suction pressure (absolute) | 1.0000 bar |
| Discharge pressure (absolute) | 4.0000 bar |
| Molar mass | 28.960 kg/kmol |
| Ratio of specific heats | 1.4000 - |
| Mean compressibility | 1.0000 - |
| Polytropic efficiency | 78.000 % |
Applying the formula below gives:
| Result | Value |
|---|---|
| Polytropic exponent term | 0.36630 |
| Polytropic head | 159.80 kJ/kg |
| Discharge temperature | 238.88 °C |
| Gas power | 1,024.4 kW |
Open this example in the calculator and change any input.
Formula
\(\frac{n - 1}{n} = \frac{k - 1}{k\eta_p}, \quad H_p = \frac{ZRT_1}{M}\frac{n}{n - 1}\left[\left(\frac{p_2}{p_1}\right)^{(n-1)/n} - 1\right], \quad T_2 = T_1\left(\frac{p_2}{p_1}\right)^{(n-1)/n}, \quad P = \frac{\dot m H_p}{\eta_p}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(\dot m\) | Gas mass flow | kg/s |
| \(T_1\) | Suction temperature | K |
| \(p_1\) | Suction pressure (absolute) | Pa |
| \(p_2\) | Discharge pressure (absolute) | Pa |
| \(M\) | Molar mass | kg/kmol |
| \(k\) | Ratio of specific heats | - |
| \(Z\) | Mean compressibility | - |
| \(\eta_p\) | Polytropic efficiency | - |
| \((n - 1)/n\) | Polytropic exponent term | - |
| \(H_p\) | Polytropic head | J/kg |
| \(T_2\) | Discharge temperature | K |
| \(P\) | Gas power | W |
Method and standards
Polytropic compression of an ideal gas with a mean Z.
Where it is used
- Process gas and air compressor checks.
Common mistakes
- Mixing isentropic and polytropic efficiencies.
- Using gauge pressures.
Assumptions and limits
- Constant k and Z; no intercooling. Above a ratio of about 4 the result is for uncooled compression and a note suggests intercooled stages.
References
- Perry's Chemical Engineers' Handbook
- 9th ed. (McGraw-Hill, 2019)
- sec. 10 (compressors): polytropic compression
Questions and answers
Why polytropic rather than isentropic?
Polytropic efficiency is independent of pressure ratio, so it is used for multistage centrifugal machines.
How is n linked to efficiency?
(n − 1)/n = (k − 1)/(k η_p).
Is Z needed?
For real gases at pressure; use the mean of suction and discharge values.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.