FireCADCalc

Dryer Thermal Efficiency and Specific Heat Use

Thermal efficiency of a convective dryer from water evaporated, latent heat and heat supplied, with the ideal adiabatic efficiency (T_in − T_out)/(T_in − T_ambient).

Refinery and petrochemicalChemical and fertiliserPulp and paperFood, dairy and textile

Inputs

Examples: 2 t/h water, 2.2 MWFlash dryer

Results

Raising the inlet temperature or lowering the exhaust temperature (within dew-point and product limits) improves efficiency most.

Thermal efficiency58.838%
Heat per kg of water evaporated3.9600MJ/kg
Adiabatic (ideal) efficiency64.516%

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 2 t/h water, 2.2 MW. The inputs, in the units selected above:

InputValue
Water evaporated2,000.0 kg/h
Latent heat of evaporation2,330.0 kJ/kg
Heat supplied to the dryer2,200.0 kW
Inlet air temperature180.00 °C
Exhaust air temperature80.000 °C
Ambient temperature25.000 °C

Applying the formula below gives:

ResultValue
Thermal efficiency58.838 %
Heat per kg of water evaporated3.9600 MJ/kg
Adiabatic (ideal) efficiency64.516 %

Open this example in the calculator and change any input.

Formula

\(\eta = \frac{E\lambda}{Q}, \quad \eta_{ad} = \frac{T_1 - T_2}{T_1 - T_0}\)

Variables

Symbol Meaning SI unit
\(E\) Water evaporated kg/s
\(\lambda\) Latent heat of evaporation J/kg
\(Q\) Heat supplied to the dryer W
\(T_1\) Inlet air temperature K
\(T_2\) Exhaust air temperature K
\(T_0\) Ambient temperature K
\(\eta\) Thermal efficiency -
\(Q/E\) Heat per kg of water evaporated J/kg
\(\eta_{ad}\) Adiabatic (ideal) efficiency -

Method and standards

Energy balance definitions.

Where it is used

  • Dryer audits.
  • Comparing dryer types.

Common mistakes

  • Ignoring product sensible heat.
  • Using LHV fuel input with HHV efficiencies.

Assumptions and limits

  • Steady operation.
  • Notes flag the impossible cases: latent heat above the heat supplied, or exhaust colder than ambient.

References

  • Perry's Chemical Engineers' Handbook
  • 9th ed. (McGraw-Hill, 2019)
  • sec. 12 (drying): thermal efficiency of convective dryers

Questions and answers

What is a good specific heat use?

Convective dryers use 3–6 MJ per kg of water; latent heat alone is about 2.4.

Why compare with the adiabatic efficiency?

It shows the best possible for the chosen air temperatures, without losses.

Why not exhaust much colder?

Humid exhaust near its dew point condenses in ducts and cyclones.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.