FireCADCalc

Boiler Chemical Cleaning: Acid for a Magnetite Deposit

Hydrochloric acid to dissolve a magnetite (Fe₃O₄) deposit by stoichiometry, with an excess, and the acid solution mass and volume at a strength.

Thermal power plantProcess steam and utilitiesSugar mill and cogenerationDistillery and ethanolBoilerWater treatment plant

Inputs

Examples: 400 kg magnetite, 5 % HClHeavy deposit

Results

Inhibited acid and the solution volume to fill the circuit both set the batch; use the larger quantity.

HCl (100 %) needed1,965.2kg
Cleaning solution28.074t
Solution volume27.124m³

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 400 kg magnetite, 5 % HCl. The inputs, in the units selected above:

InputValue
Deposit (as Fe₃O₄)400.00 kg
Excess acid50.000 %
HCl strength of the cleaning solution5.0000 %
Solution density1,025.0 kg/m³

Applying the formula below gives:

ResultValue
HCl (100 %) needed755.83 kg
Cleaning solution15.117 t
Solution volume14.748 m³

Open this example in the calculator and change any input.

Formula

\(m_{HCl} = m_d \frac{8 M_{HCl}}{M_{Fe_3O_4}}(1 + k_x), \quad m_s = \frac{m_{HCl}}{w}, \quad V_s = \frac{m_s}{\rho}\)

Variables

Symbol Meaning SI unit
\(m_d\) Deposit (as Fe₃O₄) kg
\(k_x\) Excess acid -
\(w\) HCl strength of the cleaning solution -
\(\rho\) Solution density kg/m³
\(m_{HCl}\) HCl (100 %) needed kg
\(m_s\) Cleaning solution kg
\(V_s\) Solution volume m³

Method and standards

Stoichiometry of magnetite dissolution in hydrochloric acid, Fe₃O₄ + 8 HCl → FeCl₂ + 2 FeCl₃ + 4 H₂O, with IUPAC atomic masses; the acid is raised by the excess entered and diluted to the solution strength.

Where it is used

  • Pre-commissioning and operational cleaning.

Common mistakes

  • Deposit as iron instead of Fe₃O₄.

Assumptions and limits

  • Magnetite only. The ferric chloride formed attacks the base metal and consumes more acid (often controlled with a reducing agent); copper and other deposits also take acid. The excess is the only allowance for all of these.

References

  • Fe₃O₄ + 8 HCl → FeCl₂ + 2 FeCl₃ + 4 H₂O with IUPAC atomic masses

Questions and answers

How is the deposit mass found?

From deposit weight density (g/m²) on cut tube samples times the waterside area.

Why excess acid?

Acid is consumed by other deposits and must stay above a minimum strength to the end.

Inhibitor?

Always inhibited acid, to protect the base metal.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.