FireCADCalc

Mercury Mass Balance and Stack Concentration

Mercury in, captured and emitted from the fuel's mercury content and the capture by dust and gas cleaning, with the stack concentration and yearly emission.

Thermal power plantProcess steam and utilitiesSugar mill and cogenerationDistillery and ethanolStack and chimneyDust collector (ESP, bag filter, cyclone)

Inputs

Examples: Coal 20 t/hLow capture

Use the as-fired value, not dry basis (mg/kg = ppm by mass).

Results

Capture depends on mercury speciation (oxidised mercury is caught far better than elemental) and on unburnt carbon in the ash.

Mercury in1.0000g/h
Mercury emitted0.90000g/h
Stack concentration (dry, normal, at the actual O₂)22.500µg/Nm³
Emitted per year5.4000kg

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Coal 20 t/h. The inputs, in the units selected above:

InputValue
Fuel fired20.000 t/h
Mercury in the fuel, as fired0.10000 mg/kg
Capture by ESP, filter and scrubber30.000 %
Flue gas flow (dry, normal)150,000 Nm³/h
Operating hours per year7,500.0 h

Applying the formula below gives:

ResultValue
Mercury in2.0000 g/h
Mercury emitted1.4000 g/h
Stack concentration (dry, normal, at the actual O₂)9.3333 µg/Nm³
Emitted per year10.500 kg

Open this example in the calculator and change any input.

Formula

\(\dot m_{out} = \dot m_f w_{Hg}(1 - \eta), \quad c = \frac{\dot m_{out}}{\dot V_n}\)

Variables

Symbol Meaning SI unit
\(\dot m_f\) Fuel fired kg/s
\(w_{Hg}\) Mercury in the fuel, as fired kg/kg
\(\eta\) Capture by ESP, filter and scrubber -
\(\dot V_n\) Flue gas flow (dry, normal) Nm³/s
\(t\) Operating hours per year s
\(\dot m_{in}\) Mercury in kg/s
\(\dot m_{out}\) Mercury emitted kg/s
\(c_{Hg}\) Stack concentration (dry, normal, at the actual O₂) kg/m³
\(M_a\) Emitted per year kg

Method and standards

Mass balance.

Where it is used

  • Emission inventories.
  • Compliance checks.

Common mistakes

  • mg/kg entered as g/kg.

Assumptions and limits

  • Steady firing.
  • Fuel mercury as fired (on the same basis as the fuel flow).
  • The concentration is at the actual O₂ of the gas flow entered; correct it to the reference O₂ before comparing with a limit.

References

  • Mass balance on mercury; capture share by user input

Questions and answers

Typical coal mercury?

Of the order of 0.05–0.3 mg/kg; measure your coal.

Does an ESP capture mercury?

Partly, through particle-bound and oxidised mercury; elemental mercury passes.

Units?

Mercury in fuel is usually given in mg/kg (ppm by mass); enter it as g/kg.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.