FireCADCalc

Stack Emission Rate from Concentration and Flue Gas Flow

Mass emission rate of a pollutant from its stack concentration (mg/Nm³) and the flue gas flow at the same basis, per hour, per year and per unit of fuel heat input.

Thermal power plantSugar mill and cogenerationRefinery and petrochemicalChemical and fertiliser

Inputs

Examples: Dust 50 mg/Nm3 at 150 000 Nm3/hNOx 400 mg/Nm3, no heat input

Emission limits in g/GJ are set on a gross (GCV) or net (NCV) heat input; enter the heat input on the same basis. The result follows that basis.

Results

Concentration and flow must share the basis (dry or wet, and reference O₂); correct first if they do not. The emission per heat input is on the GCV or NCV basis of the heat input entered.

Emission rate7.5000kg/h
Annual emission60.000t
Emission per heat input17.361g/GJ

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Dust 50 mg/Nm3 at 150 000 Nm3/h. The inputs, in the units selected above:

InputValue
Concentration (same basis as the flow)50.000 mg/Nm³
Flue gas flow (normal, same basis)150,000 Nm³/h
Operating hours per year8,000.0 h
Fuel heat input, GCV or NCV basis as your limit uses (0 to skip)120.00 MW

Applying the formula below gives:

ResultValue
Emission rate7.5000 kg/h
Annual emission60.000 t
Emission per heat input17.361 g/GJ

Open this example in the calculator and change any input.

Formula

\(\dot E = C\,\dot V_N, \quad E_y = \dot E\, t, \quad e = \frac{\dot E}{\dot Q_f}\)

Variables

Symbol Meaning SI unit
\(C\) Concentration (same basis as the flow) kg/m³
\(\dot V_N\) Flue gas flow (normal, same basis) Nm³/s
\(t\) Operating hours per year s
\(\dot Q_f\) Fuel heat input, GCV or NCV basis as your limit uses (0 to skip) W
\(\dot E\) Emission rate kg/s
\(E_y\) Annual emission kg
\(e\) Emission per heat input kg/J

Method and standards

Mass flow.

Where it is used

  • Emission reporting and permits.
  • Comparing with limits per GJ.

Common mistakes

  • Mixing dry concentration with wet flow.
  • Actual instead of normal flow.

Assumptions and limits

  • Steady emission.
  • The emission per heat input follows the basis of the heat input entered (gross or net calorific value); regulatory g/GJ limits differ by basis. With the heat input left at 0 it is not shown.

References

  • Mass flow = concentration × normal volume flow

Questions and answers

50 mg/Nm³ of dust in 150,000 Nm³/h?

7.5 kg/h, 60 t a year at 8000 h.

Per GJ?

About 17.4 g/GJ for 120 MW of fuel.

Different bases?

Convert wet to dry and correct to the reference O₂ before multiplying.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.