Worked example
Example: 100 ppm SO₂ at 25 °C. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Concentration (ppm by volume) | 100.00 - |
| Molar mass of the gas | 64.064 kg/kmol |
| Pressure (absolute) | 1.0132 bar |
| Temperature | 25.000 °C |
Applying the formula below gives:
| Result | Value |
|---|---|
| Concentration at p and T | 261.86 mg/m³ |
| Concentration at 0 °C and 101.325 kPa | 285.82 mg/Nm³ |
| mg/m³ per ppm at p and T | 2.6186 |
Open this example in the calculator and change any input.
Formula
\(c_m = c_v \times 10^{-6}\, \frac{p\, M}{R\, T}, \quad c_N = c_v \times 10^{-6}\, \frac{M}{V_{m,N}}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(c_v\) | Concentration (ppm by volume) | - |
| \(M\) | Molar mass of the gas | kg/kmol |
| \(p\) | Pressure (absolute) | Pa |
| \(T\) | Temperature | K |
| \(c_m\) | Concentration at p and T | kg/m³ |
| \(c_N\) | Concentration at 0 °C and 101.325 kPa | kg/m³ |
| \(k\) | mg/m³ per ppm at p and T | - |
Method and standards
Ideal gas law.
Where it is used
- Emission reporting.
- Analyser and limit comparison.
Common mistakes
- Using 24.45 L/mol for normal conditions.
- NOx as NO instead of NO₂.
Assumptions and limits
- Ideal gas.
- The result is on the same basis (wet or dry) as the ppm value; no dry-gas or reference-O₂ correction is made.
References
- Ideal gas law: mg/m³ = ppm × M p / (R T)
Questions and answers
What is 100 ppm SO₂ in mg/Nm³?
286 mg/Nm³ (at 0 °C, 1 atm).
And NOx?
Reported as NO₂ (46.0 g/mol): 1 ppm = 2.05 mg/Nm³.
Why is it different at 25 °C?
A cubic metre at 25 °C holds 8 % less gas than at 0 °C.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.