Worked example
Example: 80 % reduction, 25 % aqueous. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Flue gas flow (dry, normal) | 100,000 Nm³/h |
| NOx at the inlet (as NO₂, dry) | 400.00 mg/Nm³ |
| NOx reduction wanted | 80.000 % |
| Ammonia slip (dry, by volume) | 3.0000 ppm |
| Ammonia strength of the reagent (1 for anhydrous) | 25.000 % |
Applying the formula below gives:
| Result | Value |
|---|---|
| Ammonia (100 %) | 12.074 kg/h |
| Reagent | 48.297 kg/h |
| Molar ratio to inlet NOx | 0.81539 |
Open this example in the calculator and change any input.
Formula
\(\dot n_{NH_3} = \eta\,\dot n_{NO_x} + \frac{\dot V_n y_{NH_3}}{V_m}, \quad \dot m_r = \frac{\dot n_{NH_3} M_{NH_3}}{w}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(\dot V_n\) | Flue gas flow (dry, normal) | Nm³/s |
| \(c_{NO_x}\) | NOx at the inlet (as NO₂, dry) | kg/m³ |
| \(\eta\) | NOx reduction wanted | - |
| \(y_{NH_3}\) | Ammonia slip (dry, by volume) | - |
| \(w\) | Ammonia strength of the reagent (1 for anhydrous) | - |
| \(\dot m_{NH_3}\) | Ammonia (100 %) | kg/s |
| \(\dot m_r\) | Reagent | kg/s |
| \(NH_3/NO_x\) | Molar ratio to inlet NOx | - |
Method and standards
Stoichiometry of the standard SCR reaction, one NH₃ per NOx molecule reduced (NOx counted as NO₂ for its mass), plus the slip at the outlet on the molar volume at 0 °C and 1 atm.
Where it is used
- SCR reagent systems.
- Operating cost estimates.
Common mistakes
- Slip in mg/Nm³ entered as ppm.
Assumptions and limits
- Dry, normal basis.
- All NOx is treated as NO reacting 1 : 1. NO₂ (usually 5–10 % of boiler NOx) reacts by other routes and ammonia lost by oxidation on the catalyst is not counted; allow a margin on the dose from the catalyst maker.
References
- Stoichiometry 4 NO + 4 NH₃ + O₂ → 4 N₂ + 6 H₂O (NH₃ : NO = 1); slip on the molar volume at 0 °C
- 1 atm
Questions and answers
Why 1 : 1?
The standard SCR reaction consumes one NH₃ per NO.
NO₂ in the NOx?
Mostly NO in boiler flue gas; reporting as NO₂ is a convention for mass.
Aqueous or anhydrous?
25 % aqueous ammonia is easier to permit and store; anhydrous needs a smaller tank.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.