FireCADCalc

Wash (Beer) Alcohol from Sugar in the Mash

Alcohol strength of the fermented wash in % v/v and g/L from the fermentable sugar concentration of the mash and the fermentation efficiency.

Distillery and ethanol

Inputs

Examples: 180 g/L sugarHigh gravity 250 g/L

Results

Volume change during fermentation is neglected; high-gravity mashes need tolerant yeast.

Ethanol in wash117.63g/L
Wash strength14.904%

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 180 g/L sugar. The inputs, in the units selected above:

InputValue
Fermentable sugar in the mash (as invert)180.00 g/L
Fermentation efficiency90.000 %
Ethanol density at 20 °C789.24 kg/m³

Applying the formula below gives:

ResultValue
Ethanol in wash82.852 g/L
Wash strength10.498 %

Open this example in the calculator and change any input.

Formula

\(c_e = c_s \frac{2 M_{EtOH}}{M_{C_6H_{12}O_6}} \eta_f, \quad s_v = \frac{c_e}{\rho_e}\)

Variables

Symbol Meaning SI unit
\(c_s\) Fermentable sugar in the mash (as invert) kg/m³
\(\eta_f\) Fermentation efficiency -
\(\rho_e\) Ethanol density at 20 °C kg/m³
\(c_e\) Ethanol in wash kg/m³
\(s_v\) Wash strength -

Method and standards

Stoichiometry.

Where it is used

  • Fermentation set-up.
  • Spent wash reduction.

Common mistakes

  • Total sugar used for fermentable.

Assumptions and limits

  • No volume change: mash and wash volumes are taken as equal. Sugar consumed and CO₂ released reduce the volume, so the wash strength in % v/v is slightly understated.

References

  • Gay-Lussac stoichiometry C₆H₁₂O₆ → 2 C₂H₅OH + 2 CO₂ with IUPAC atomic masses; ethanol density 789.24 kg/m³ at 20 °C (OIML R 22)

Questions and answers

Typical molasses wash?

About 8–10 % v/v; grain fermentations reach 12–15 % with high-gravity mashes.

Why not more sugar?

Ethanol inhibits yeast; osmotic stress also slows fermentation.

Higher wash strength saves what?

Less wash to distil and less spent wash per litre.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.