Worked example
Example: 100 KLPD, 70 % recovered. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Ethanol produced (absolute) | 100.00 kL/d |
| Share of CO₂ recovered | 70.000 % |
| Recovery and liquefaction energy | 150.00 kWh/t |
| Ethanol density at 20 °C | 789.24 kg/m³ |
Applying the formula below gives:
| Result | Value |
|---|---|
| CO₂ released | 75.395 t/d |
| CO₂ at normal conditions | 1,600.0 Nm³/h |
| CO₂ recovered | 52.776 t/d |
| Recovery plant power | 329.85 kW |
Open this example in the calculator and change any input.
Formula
\(\dot m_{CO_2} = \dot V_e \rho_e \frac{M_{CO_2}}{M_{EtOH}}, \quad \dot V_{CO_2} = \frac{\dot m_{CO_2}}{M_{CO_2}} V_m, \quad \dot m_r = r\,\dot m_{CO_2}, \quad P = e\,\dot m_r\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(\dot V_e\) | Ethanol produced (absolute) | m³/s |
| \(r\) | Share of CO₂ recovered | - |
| \(e\) | Recovery and liquefaction energy | J/kg |
| \(\rho_e\) | Ethanol density at 20 °C | kg/m³ |
| \(\dot m_{CO_2}\) | CO₂ released | kg/s |
| \(\dot V_{CO_2}\) | CO₂ at normal conditions | Nm³/s |
| \(\dot m_r\) | CO₂ recovered | kg/s |
| \(P\) | Recovery plant power | W |
Method and standards
Stoichiometry.
Where it is used
- CO₂ recovery plants.
- Carbon accounting.
Common mistakes
- Molar mass in g/mol with mass in kg.
Assumptions and limits
- Ideal gas.
References
- Gay-Lussac stoichiometry C₆H₁₂O₆ → 2 C₂H₅OH + 2 CO₂ with IUPAC atomic masses; ethanol density 789.24 kg/m³ at 20 °C (OIML R 22)
- Normal volume with the molar volume at 0 °C
- 1 atm (CODATA)
Questions and answers
How much CO₂ per litre of ethanol?
About 0.75 kg: 0.955 kg per kg of ethanol.
Why not recover all of it?
Early-fermentation gas is dilute and some is lost at vents.
Recovery energy?
Scrubbing, compression and refrigeration: take the plant supplier's figure.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.