Worked example
Example: 10 % vol beer at 32 °C, 100 m3/day. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Beer strength | 10.000 % |
| Beer temperature | 32.000 °C |
| Pressure in the fermenter head space | 101.33 kPa |
| Ethanol production at 20 °C | 4.1667 m³/h |
Applying the formula below gives:
| Result | Value |
|---|---|
| Ethanol mole fraction in the gas | 2.3563 % |
| Water vapour mole fraction | 4.5657 % |
| Ethanol lost as a share of production | 2.5315 % |
| Ethanol lost at 20 °C | 0.10548 m³/h |
Open this example in the calculator and change any input.
Formula
\(y_e = \frac{x_e\gamma_e p_e^s(T)}{P}, \quad y_w = \frac{x_w\gamma_w p_w^s(T)}{P}, \quad \varepsilon = \frac{y_e}{1 - y_e - y_w}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(q\) | Beer strength | - |
| \(T\) | Beer temperature | K |
| \(P\) | Pressure in the fermenter head space | Pa |
| \(\dot V_e\) | Ethanol production at 20 °C | m³/s |
| \(y_e\) | Ethanol mole fraction in the gas | - |
| \(y_w\) | Water vapour mole fraction | - |
| \(\varepsilon\) | Ethanol lost as a share of production | - |
| \(\dot V_L\) | Ethanol lost at 20 °C | m³/s |
Method and standards
Saturated off-gas with Wilson activity coefficients; CO₂ moles equal ethanol moles produced.
Where it is used
- Distillery yield audits.
- Scrubber justification.
Common mistakes
- Ignoring the loss in yield balances.
- Using Raoult's law without γ (understates about sixfold).
Assumptions and limits
- Gas saturated at beer temperature; dissolved CO₂ and solids ignored; Wilson model fitted near 78–100 °C, extrapolated to fermenter temperatures.
- The loss is proportional to the activity coefficient of ethanol, which is extrapolated here and has not been compared with measured values at 10–40 °C; if it is overstated, so is the loss.
References
- Ethanol–water VLE at about 1 atm: Wilson equation (Perry's Chemical Engineers' Handbook, 9th ed., sec. 4) with energies 399 and 933 cal/mol fitted to FireCAD ethanol–water x–y–T data at 101.325 kPa; ethanol vapour pressure Perry's 9th ed. Table 2-8; water IAPWS-IF97
- Stoichiometry: one mole of CO₂ per mole of ethanol (Gay-Lussac)
Questions and answers
Why does CO₂ carry ethanol?
Each mole of CO₂ leaves saturated with ethanol vapour at the beer's partial pressure.
How big is the loss?
For 10 % vol beer at 32 °C saturated gas carries about 2.5 % of the ethanol made; measured losses are lower because the gas is not fully saturated.
Is the gas saturated?
Nearly, in a vigorously gassing fermenter; the calculation gives the upper bound.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.