FireCADCalc

Grain Mash: Water, Slurry Solids and Mash Flow

Water to mix with milled grain for a target slurry solids, the mash flow and the water-to-grain ratio, by a dry-solids balance.

Distillery and ethanol

Inputs

Examples: 250 t/d grain, 30 % solidsRice 32 % solids

Results

Water (and backset) to add475.00t/d
Mash (slurry)725.00t/d
Water-to-grain ratio1.9000

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 250 t/d grain, 30 % solids. The inputs, in the units selected above:

InputValue
Grain250.00 t/d
Grain moisture13.000 %
Target slurry dry solids30.000 %

Applying the formula below gives:

ResultValue
Water (and backset) to add475.00 t/d
Mash (slurry)725.00 t/d
Water-to-grain ratio1.9000

Open this example in the calculator and change any input.

Formula

\(\dot m_s = \frac{\dot m_g (1 - w)}{TS}, \quad \dot m_w = \dot m_s - \dot m_g\)

Variables

Symbol Meaning SI unit
\(\dot m_g\) Grain kg/s
\(w\) Grain moisture -
\(TS\) Target slurry dry solids -
\(\dot m_w\) Water (and backset) to add kg/s
\(\dot m_s\) Mash (slurry) kg/s
\(r\) Water-to-grain ratio -

Method and standards

Dry-solids balance.

Where it is used

  • Grain distillery design.
  • Mash control.

Common mistakes

  • Wet grain counted as dry.

Assumptions and limits

  • Steady flow.
  • Backset (thin stillage) is counted as water, but it carries several per cent of dissolved solids, so the real slurry solids are somewhat above TS when backset is used. Count those solids in the target if you need the true figure.

References

  • Dry-solids balance

Questions and answers

Why about 30 % solids?

Higher solids raise wash strength but thicken the mash.

Backset?

Part of the water can be thin stillage; it counts in the water here.

Grain moisture?

Use as-received moisture so the balance closes.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.