FireCADCalc

Ethanol Carried Off in Fermenter CO₂

Ethanol and water vapour in the CO₂ leaving a fermenter saturated at beer temperature, and the ethanol lost as a share of production (Wilson VLE, 1 CO₂ per ethanol).

Distillery and ethanolIAPWS-IF97 (water and steam)Tank and drum

Inputs

Examples: 10 % vol beer at 32 °C, 100 m3/day14 % vol at 35 °C

% vol at 20 °C.

Results

A CO₂ scrubber recovers most of this ethanol; the loss share rises with beer strength and temperature.

Ethanol mole fraction in the gas3.4957%
Water vapour mole fraction5.3450%
Ethanol lost as a share of production3.8347%
Ethanol lost at 20 °C0.31956m³/h

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 10 % vol beer at 32 °C, 100 m3/day. The inputs, in the units selected above:

InputValue
Beer strength10.000 %
Beer temperature32.000 °C
Pressure in the fermenter head space101.33 kPa
Ethanol production at 20 °C4.1667 m³/h

Applying the formula below gives:

ResultValue
Ethanol mole fraction in the gas2.3563 %
Water vapour mole fraction4.5657 %
Ethanol lost as a share of production2.5315 %
Ethanol lost at 20 °C0.10548 m³/h

Open this example in the calculator and change any input.

Formula

\(y_e = \frac{x_e\gamma_e p_e^s(T)}{P}, \quad y_w = \frac{x_w\gamma_w p_w^s(T)}{P}, \quad \varepsilon = \frac{y_e}{1 - y_e - y_w}\)

Variables

Symbol Meaning SI unit
\(q\) Beer strength -
\(T\) Beer temperature K
\(P\) Pressure in the fermenter head space Pa
\(\dot V_e\) Ethanol production at 20 °C m³/s
\(y_e\) Ethanol mole fraction in the gas -
\(y_w\) Water vapour mole fraction -
\(\varepsilon\) Ethanol lost as a share of production -
\(\dot V_L\) Ethanol lost at 20 °C m³/s

Method and standards

Saturated off-gas with Wilson activity coefficients; CO₂ moles equal ethanol moles produced.

Where it is used

  • Distillery yield audits.
  • Scrubber justification.

Common mistakes

  • Ignoring the loss in yield balances.
  • Using Raoult's law without γ (understates about sixfold).

Assumptions and limits

  • Gas saturated at beer temperature; dissolved CO₂ and solids ignored; Wilson model fitted near 78–100 °C, extrapolated to fermenter temperatures.
  • The loss is proportional to the activity coefficient of ethanol, which is extrapolated here and has not been compared with measured values at 10–40 °C; if it is overstated, so is the loss.

References

  • Ethanol–water VLE at about 1 atm: Wilson equation (Perry's Chemical Engineers' Handbook, 9th ed., sec. 4) with energies 399 and 933 cal/mol fitted to FireCAD ethanol–water x–y–T data at 101.325 kPa; ethanol vapour pressure Perry's 9th ed. Table 2-8; water IAPWS-IF97
  • Stoichiometry: one mole of CO₂ per mole of ethanol (Gay-Lussac)

Questions and answers

Why does CO₂ carry ethanol?

Each mole of CO₂ leaves saturated with ethanol vapour at the beer's partial pressure.

How big is the loss?

For 10 % vol beer at 32 °C saturated gas carries about 2.5 % of the ethanol made; measured losses are lower because the gas is not fully saturated.

Is the gas saturated?

Nearly, in a vigorously gassing fermenter; the calculation gives the upper bound.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.