Worked example
Example: Fresh roots 25 % starch. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Cassava (roots or chips) | 10.000 t/h |
| Starch content | 25.000 % |
| Overall efficiency (conversion, fermentation, distillation) | 85.000 % |
| Ethanol density at 20 °C | 789.24 kg/m³ |
Applying the formula below gives:
| Result | Value |
|---|---|
| Glucose from the starch per tonne | 277.78 kg/t |
| Theoretical ethanol per tonne | 180.00 L/t |
| Ethanol per tonne | 153.00 L/t |
| Ethanol | 1,530.0 L/h |
Open this example in the calculator and change any input.
Formula
\(m_G = x_S\frac{M_G}{M_G - M_W}, \quad Y_t = \frac{m_G\,2M_E/M_G}{\rho_e}, \quad Y = \eta Y_t\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(\dot m\) | Cassava (roots or chips) | kg/s |
| \(x_S\) | Starch content | - |
| \(\eta\) | Overall efficiency (conversion, fermentation, distillation) | - |
| \(\rho_e\) | Ethanol density at 20 °C | kg/m³ |
| \(m_G\) | Glucose from the starch per tonne | kg/kg |
| \(Y_t\) | Theoretical ethanol per tonne | m³/kg |
| \(Y\) | Ethanol per tonne | m³/kg |
| \(\dot V_E\) | Ethanol | m³/s |
Method and standards
Hydrolysis and fermentation stoichiometry.
Where it is used
- Feedstock planning.
- Comparing cassava and grain.
Common mistakes
- Using dry-basis starch with fresh-root tonnage.
- Leaving out losses.
Assumptions and limits
- Starch fully hydrolysed to glucose. A note appears when a fresh-root case (starch below 40 %) gives more than the 70–110 L/t the Alcohol Textbook reports.
References
- Jacques
- Lyons and Kelsall (eds.)
- The Alcohol Textbook
- 4th ed. (Nottingham University Press, 2003)
- ch. 6 (Vinh)
- ethanol production from cassava
- Stoichiometry: (C₆H₁₀O₅)ₙ + n H₂O → n C₆H₁₂O₆ → 2n C₂H₅OH + 2n CO₂
Questions and answers
Why does starch gain weight?
Each glucose unit takes up a water molecule on hydrolysis: 1 kg starch gives 1.11 kg glucose.
Why so little from fresh roots?
Roots are about two-thirds water; chips dried to 14 % moisture carry 65–70 % starch.
Typical efficiency?
Plants reach 85–90 % of theoretical with good liquefaction and fermentation.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.