Worked example
Example: Carbide at 150 m/min. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Cutting speed | 150.00 m/min |
| Taylor exponent | 0.25000 - |
| Taylor constant: cutting speed for a 1 min tool life | 400.00 m/min |
| Target tool life | 30.000 min |
Applying the formula below gives:
| Result | Value |
|---|---|
| Tool life at V | 50.568 min |
| Speed for the target life | 170.91 m/min |
Open this example in the calculator and change any input.
Formula
\(V T^n = C\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(V\) | Cutting speed | m/s |
| \(n\) | Taylor exponent | - |
| \(C\) | Taylor constant: cutting speed for a 1 min tool life | m/s |
| \(T_t\) | Target tool life | s |
| \(T\) | Tool life at V | s |
| \(V_t\) | Speed for the target life | m/s |
Method and standards
Taylor.
Where it is used
- Tool change planning.
- Machining economics.
Common mistakes
- m/s with constants in m/min.
- Extrapolating far beyond the data.
Assumptions and limits
C is the cutting speed that gives a 1 min tool life, so it can be entered in any speed unit; the equation is evaluated with V in m/min and T in minutes. Constants fitted with T in seconds or hours must be converted first.
Lives outside about 1–1000 min are flagged: small n makes T extremely sensitive to speed, and extrapolation beyond the fitted speeds is unreliable.
Same tool, work and feed as the constants.
References
- Taylor (1907) V Tⁿ = C
Questions and answers
Carbide n 0.25, C 400, at 150 m/min?
About 51 minutes.
Speed for 30 min?
About 171 m/min.
Why does speed hurt so much?
Life varies as speed to the power −1/n: −4 for n = 0.25.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.