FireCADCalc

Surface Roughness in Turning: Ra from Feed and Nose Radius

Theoretical surface roughness (Ra and peak-to-valley Rt) of a turned surface from the feed and the tool nose radius, and the feed for a target Ra.

Inputs

Examples: 0.2 mm/rev, 0.8 mm nose0.1 mm/rev, 0.4 mm nose

Results

Geometric value; real roughness is higher due to built-up edge, vibration and tool wear.

Theoretical Ra f²/(32r)0.78125µm
Peak-to-valley f²/(8r)3.1250µm
Feed for the target Ra0.10119mm

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 0.2 mm/rev, 0.8 mm nose. The inputs, in the units selected above:

InputValue
Feed per revolution0.20000 mm
Tool nose radius0.80000 mm
Target Ra1.6000 µm

Applying the formula below gives:

ResultValue
Theoretical Ra f²/(32r)1.5625 µm
Peak-to-valley f²/(8r)6.2500 µm
Feed for the target Ra0.20239 mm

Open this example in the calculator and change any input.

Formula

\(R_a \approx \frac{f^2}{32 r_\varepsilon}, \quad R_t = \frac{f^2}{8 r_\varepsilon}\)

Variables

Symbol Meaning SI unit
\(f\) Feed per revolution m
\(r_\varepsilon\) Tool nose radius m
\(R_{a,t}\) Target Ra m
\(R_a\) Theoretical Ra f²/(32r) m
\(R_t\) Peak-to-valley f²/(8r) m
\(f_t\) Feed for the target Ra m

Method and standards

Geometry.

Where it is used

  • Finishing passes.
  • Shaft journals and seal faces.

Common mistakes

  • Expecting the theoretical value in practice.
  • Feed in mm/min.

Assumptions and limits

  • R_a = f²/(32 r) is the usual approximation (R_a = R_t/4). The exact mean deviation of a circular-arc cusp is f²/(18√3 r) = f²/(31.2 r), about 2.6 % higher; the difference is far smaller than the effect of wear and vibration.

  • Valid when the feed is well below the nose radius; the page warns when f exceeds r and when f reaches 2r, where the nose arc no longer forms the whole cusp.

  • Sharp tool, no vibration.

References

  • Geometric roughness R_t = f²/(8r)
  • R_a ≈ f²/(32r) (Kalpakjian; Sandvik turning formulas)

Questions and answers

0.2 mm/rev with a 0.8 mm nose?

Ra about 1.56 µm.

Feed for Ra 1.6 µm?

About 0.20 mm/rev.

Wiper inserts?

They allow higher feed for the same finish.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.