FireCADCalc

Process Yield and Scrap Through Several Stages

Overall yield and the starts needed for a good-part quantity through up to three process stages with their scrap rates.

Inputs

Examples: Three stagesHigh scrap first stage

Results

Overall yield83.300%
Starts needed (rounded up)601.00
Starts minus good parts needed (scrap plus rounding surplus)101.00

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Three stages. The inputs, in the units selected above:

InputValue
Good parts needed1,000.0 -
Scrap at stage 13.0000 %
Scrap at stage 25.0000 %
Scrap at stage 32.0000 %

Applying the formula below gives:

ResultValue
Overall yield90.307 %
Starts needed (rounded up)1,108.0
Starts minus good parts needed (scrap plus rounding surplus)108.00

Open this example in the calculator and change any input.

Formula

\(Y = \prod_i (1 - s_i), \quad N_0 = \left\lceil\frac{Q}{Y}\right\rceil, \quad N_s = N_0 - Q\)

Variables

Symbol Meaning SI unit
\(Q\) Good parts needed -
\(s_1\) Scrap at stage 1 -
\(s_2\) Scrap at stage 2 -
\(s_3\) Scrap at stage 3 -
\(Y\) Overall yield -
\(N_0\) Starts needed (rounded up) -
\(N_s\) Starts minus good parts needed (scrap plus rounding surplus) -

Method and standards

Chained yields.

Where it is used

  • Production planning and costing.
  • Quality improvement cases.

Common mistakes

  • Adding scrap rates.
  • Ignoring rework loops.

Assumptions and limits

  • Independent stages; scrap rates are expected averages.
  • N_s = N_0 − Q includes the surplus from rounding the starts up (good parts beyond Q), so it can exceed the expected scrap by up to one part per stage; stage-by-stage whole-part scrap may differ.

References

  • Rolled throughput yield Y = Π(1 − s_i)

Questions and answers

1000 good parts through 3 %, 5 % and 2 % scrap?

Yield 90.3 %: start 1108.

Why multiply?

Each stage only sees what survived the one before.

Rework?

Parts reworked and passed are not scrap; treat them separately.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.