FireCADCalc

Milling Table Feed from Feed per Tooth

Table feed rate of a milling cutter from feed per tooth, number of teeth and spindle speed, with the spindle speed for a cutting speed.

Inputs

Examples: 63 mm, 6 teeth16 mm end mill, 4 flutes

Results

Spindle speed2,387.3rpm
Table feed477.46mm/min

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 63 mm, 6 teeth. The inputs, in the units selected above:

InputValue
Feed per tooth0.10000 mm
Number of teeth6.0000 -
Cutter diameter63.000 mm
Cutting speed200.00 m/min

Applying the formula below gives:

ResultValue
Spindle speed1,010.5 rpm
Table feed606.30 mm/min

Open this example in the calculator and change any input.

Formula

\(N = \frac{v_c}{\pi D}, \quad v_f = f_z\, z\, N\)

Variables

Symbol Meaning SI unit
\(f_z\) Feed per tooth m
\(z\) Number of teeth -
\(D\) Cutter diameter m
\(v_c\) Cutting speed m/s
\(N\) Spindle speed 1/s
\(v_f\) Table feed m/s

Method and standards

Kinematics.

Where it is used

  • CNC programming.
  • Workshop set-up.

Common mistakes

  • Feed per revolution for feed per tooth.
  • Wrong tooth count.

Assumptions and limits

  • Full engagement. No spindle-speed limit of the machine and no chip-thinning correction (at radial engagement below half the diameter, raise f_z to keep the chip thickness).

References

  • v_f = f_z z N; N = v_c/(πD)

Questions and answers

63 mm six-tooth cutter, 200 m/min, 0.1 mm/tooth?

About 1011 rpm and 606 mm/min.

Too small a chip?

Rubbing and fast wear; keep feed per tooth in the maker's range.

Chip thinning?

Light radial cuts need more feed per tooth for the same chip thickness.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.