FireCADCalc

Injection Moulding Clamping Force

Clamping force for an injection moulding tool from the projected area of the parts and runner, cavity pressure, number of cavities and a safety margin.

Inputs

Examples: Four 120 cm2 partsSingle large cover

From the material maker or flow analysis; depends on flow length and wall thickness.

Results

Total projected area830.00cm²
Clamping force2,739.0kN
Clamping force in press units279.30tf

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Four 120 cm2 parts. The inputs, in the units selected above:

InputValue
Projected area of one part120.00 cm²
Number of cavities4.0000 -
Projected area of the runner20.000 cm²
Mean cavity pressure (gauge)35.000 MPa
Safety margin15.000 %

Applying the formula below gives:

ResultValue
Total projected area500.00 cm²
Clamping force2,012.5 kN
Clamping force in press units205.22 tf

Open this example in the calculator and change any input.

Formula

\(F = (n A_p + A_r)\, p_c\, (1 + k)\)

Variables

Symbol Meaning SI unit
\(A_p\) Projected area of one part m²
\(n\) Number of cavities -
\(A_r\) Projected area of the runner m²
\(p_c\) Mean cavity pressure (gauge) Pa
\(k\) Safety margin -
\(A\) Total projected area m²
\(F\) Clamping force N
\(P\) Clamping force in press units N

Method and standards

Force balance.

Where it is used

  • Machine selection.
  • Tool quoting.

Common mistakes

  • Part surface area instead of projected area.
  • Forgetting the runner.

Assumptions and limits

  • Uniform mean cavity pressure (gauge; the atmosphere acts on both sides of the mould).
  • The press rating is shown in tonne-force (kip in FPS).

References

  • F = projected area × cavity pressure × (1 + margin)

Questions and answers

Four 120 cm² parts and 20 cm² of runner at 35 MPa?

About 2012 kN: a 205 t machine.

Thin walls?

Long flows in thin walls need much higher pressure.

Flash?

Too little clamp lets the tool open: flash.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.