FireCADCalc

Deep Drawing: Blank Diameter and Draw Ratio (Cylindrical Cup)

Blank diameter for a cylindrical cup from its diameter and height by surface-area equality, the draw ratio and the number of draws for a limiting draw ratio.

Inputs

Examples: 80 mm cup, 60 mm tallTall cup needing redrawsTall cup, redraw ratio 1.3

About 1.8–2.2 for first draws of steel.
Redraw ratios are lower than the first draw's; from your tooling data.

Results

Thin sheet, sharp corners and no flange; corner radii and flanges change the blank.

Blank diameter163.95mm
Total draw ratio2.0494
Draws needed at the LDR2.0000

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 80 mm cup, 60 mm tall. The inputs, in the units selected above:

InputValue
Cup diameter (mean)80.000 mm
Cup height60.000 mm
Trim allowance on height4.0000 mm
Limiting draw ratio, first draw2.0000 -
Limiting draw ratio for redraws (0 = same as the first)0 -

Applying the formula below gives:

ResultValue
Blank diameter163.95 mm
Total draw ratio2.0494
Draws needed at the LDR2.0000

Open this example in the calculator and change any input.

Formula

\(D = \sqrt{d^2 + 4dh}, \quad n = 1 + \left\lceil\frac{\ln(D/(d\,LDR))}{\ln LDR_r}\right\rceil\ (D/d > LDR;\ \text{else}\ 1)\)

Variables

Symbol Meaning SI unit
\(d\) Cup diameter (mean) m
\(h\) Cup height m
\(\Delta h\) Trim allowance on height m
\(LDR\) Limiting draw ratio, first draw -
\(LDR_r\) Limiting draw ratio for redraws (0 = same as the first) -
\(D\) Blank diameter m
\(D/d\) Total draw ratio -
\(n\) Draws needed at the LDR -

Method and standards

Area equality.

Where it is used

  • Pressed cups, cans and housings.
  • Tool design.

Common mistakes

  • Outside instead of mean diameter.
  • One draw beyond the LDR.

Assumptions and limits

  • Thin sheet, constant thickness.
  • The first draw uses LDR and each redraw LDR_r (lower in practice); with LDR_r = 0 every draw uses LDR, which underestimates the count for tall cups.

References

  • Surface-area equality for a thin cylindrical cup D = √(d² + 4dh); limiting draw ratio (Kalpakjian; Schuler, Metal Forming Handbook)

Questions and answers

80 mm cup, 60 mm tall with 4 mm trim?

Blank about 164 mm, ratio 2.05: just over an LDR of 2, so two draws (or a shallower first draw and a redraw).

Taller cups?

Need redraws, each at a smaller ratio.

Why trim allowance?

Earing leaves an uneven rim to cut off.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.