FireCADCalc

Sludge Volume from Dry Solids, Solids Content and Specific Gravity

Wet sludge volume and mass from the dry solids, the solids content and the specific gravity of the solids (Metcalf & Eddy relation), for thickening and disposal.

Refinery and petrochemicalChemical and fertiliserPulp and paperFood, dairy and textile

Inputs

Examples: Biological sludge 4 % to 22 %Lime sludge 10 % to 45 %

Results

Specific gravity of the sludge1.0116
Sludge volume per day37.071m³/d
Wet sludge mass per day37.500t/d
Volume after dewatering6.3896m³/d

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Biological sludge 4 % to 22 %. The inputs, in the units selected above:

InputValue
Dry solids per day1,500.0 kg/d
Solids content of the sludge4.0000 %
Specific gravity of the dry solids1.4000 -
Solids content after dewatering22.000 %

Applying the formula below gives:

ResultValue
Specific gravity of the sludge1.0116
Sludge volume per day37.071 m³/d
Wet sludge mass per day37.500 t/d
Volume after dewatering6.3896 m³/d

Open this example in the calculator and change any input.

Formula

\(\frac{1}{S_{sl}} = \frac{P_s}{S_s} + (1 - P_s), \quad \dot V = \frac{M_s}{\rho_w S_{sl} P_s}\)

Variables

Symbol Meaning SI unit
\(M_s\) Dry solids per day kg/s
\(P_s\) Solids content of the sludge -
\(S_s\) Specific gravity of the dry solids -
\(P_{s2}\) Solids content after dewatering -
\(S_{sl}\) Specific gravity of the sludge -
\(\dot V\) Sludge volume per day m³/s
\(\dot m\) Wet sludge mass per day kg/s
\(\dot V_2\) Volume after dewatering m³/s

Method and standards

Mass and volume balance.

Where it is used

  • Sludge handling and disposal.
  • Filter press and centrifuge sizing.

Common mistakes

  • Percent for fraction.
  • Ignoring the solids SG for mineral sludge.

Assumptions and limits

  • No gas in the sludge.
  • The dewatered solids content should be above the feed solids content; the page warns otherwise.

References

  • V = M_s/(ρ_w S_sl P_s)
  • 1/S_sl = P_s/S_s + (1 − P_s) (Metcalf & Eddy, Wastewater Engineering)

Questions and answers

1500 kg/day of solids at 4 %, SG 1.4?

About 37.1 m³/day; at 22 % about 6.4 m³/day.

Why does dewatering matter so much?

Volume is almost inversely proportional to solids content.

SG of solids?

Organic sludge solids about 1.0–1.4, mineral (ash, lime) 2–2.6.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.