Worked example
Example: Ganapathy: 25 lb/h NOx, 15 lb/h CO in 550,000 lb/h. The inputs, in the units selected above:
| Input | Value |
|---|---|
| NOx (as NO₂) | 11.340 kg/h |
| CO | 6.8039 kg/h |
| Exhaust gas flow (wet) | 249.48 t/h |
| Exhaust molar mass (wet gas) | 28.000 kg/kmol |
| Water vapour in the exhaust (vol, wet) | 10.000 % |
| Oxygen in the exhaust (vol, wet) | 11.500 % |
| Reference oxygen (dry) | 15.000 % |
| O₂ in air used by the rule | 21.000 % |
Applying the formula below gives:
| Result | Value |
|---|---|
| NO₂ mole fraction, dry | 30.739 ppm |
| Correction factor to the reference O₂ | 0.72973 |
| NOx, ppmvd at the reference O₂ | 22.431 ppm |
| CO, ppmvd at the reference O₂ | 22.105 ppm |
Open this example in the calculator and change any input.
Formula
\(V = \frac{w/M_{NO_2}}{W/MW}\cdot\frac{1}{1 - H_2O}, \quad V_{ref} = V\,\frac{O_{2,air} - O_{2,ref}}{O_{2,air} - O_2/(1 - H_2O)}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(w_{NO_x}\) | NOx (as NO₂) | kg/s |
| \(w_{CO}\) | CO | kg/s |
| \(W\) | Exhaust gas flow | kg/s |
| \(MW\) | Exhaust molar mass | kg/kmol |
| \(H_2O\) | Water vapour in the exhaust (vol, wet) | - |
| \(O_2\) | Oxygen in the exhaust (vol, wet) | - |
| \(O_{2,ref}\) | Reference oxygen (dry) | - |
| \(O_{2,air}\) | O₂ in air used by the rule (21 % default; 20.9 % in US EPA practice) | - |
| \(V\) | NO₂ mole fraction, dry | - |
| \(F\) | Correction factor to the reference O₂ | - |
| \(V_{NO_x}\) | NOx, ppmvd at the reference O₂ | - |
| \(V_{CO}\) | CO, ppmvd at the reference O₂ | - |
Method and standards
Ganapathy's mole balance with the standard oxygen correction.
Where it is used
- Gas turbine and HRSG permits.
- CEMS checks.
Common mistakes
- Correcting with wet oxygen.
- Reporting NOx as NO.
Assumptions and limits
- Ideal gas; exhaust analysis known. The exhaust flow and molar mass are on the wet basis (\(W/MW\) is the total wet kmol).
- In US units the NOx and CO flows are shown in lb/h.
- A note appears when the dry O₂ is above 18 %.
References
- Ganapathy
- Steam Plant Calculations Manual
- 2nd ed. (Marcel Dekker, 1993)
- Q2.26a
- Eqs. (19) and (20)
- Molar masses NO₂ and CO from IUPAC atomic masses
Questions and answers
Why dry and at 15 % O₂?
Regulations for gas turbines compare plants on a dry basis at 15 % oxygen so dilution cannot hide emissions.
Why is NOx counted as NO₂?
Convention: NO converts to NO₂ in the atmosphere.
What does Ganapathy's example give?
25 lb/h NOx and 15 lb/h CO in 550,000 lb/h exhaust give about 22 ppmvd NOx and 22 ppmvd CO at 15 % O₂ by its Eqs. (19)–(20); the printed 16.4 is an arithmetic slip.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.