FireCADCalc

Hydraulic Diameter of Ducts and Channels

Hydraulic diameter of a rectangular duct, an annulus, or a partly full circular pipe from the flow area and wetted perimeter, for Reynolds number and friction.

Process steam and utilitiesRefinery and petrochemicalChemical and fertiliser

Inputs

Examples: Duct 400 × 200 mmAnnulus 100 / 60 mmPipe 600 mm half full

Results

For the partly full pipe only the wetted arc counts (open channel); the free surface is not part of the perimeter.

Flow area0.080000m²
Wetted perimeter1.2000m
Hydraulic diameter 4A/P266.67mm

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Duct 400 × 200 mm. The inputs, in the units selected above:

InputValue
Cross-sectionRectangle a × b, full
Width a, outer diameter D400.00 mm
Height b, inner diameter d, or depth h200.00 mm

Applying the formula below gives:

ResultValue
Flow area0.080000 m²
Wetted perimeter1.2000 m
Hydraulic diameter 4A/P266.67 mm

Open this example in the calculator and change any input.

Formula

\(D_h = \frac{4A}{P_w}\)

Variables

Symbol Meaning SI unit
\(\text{shape}\) Cross-section -
\(a\) Width a, outer diameter D m
\(b\) Height b, inner diameter d, or depth h m
\(A\) Flow area m²
\(P_w\) Wetted perimeter m
\(D_h\) Hydraulic diameter 4A/P m

Method and standards

Definition.

Where it is used

  • Non-circular ducts and annuli.
  • Heat exchanger shells and channels.

Common mistakes

  • Using D_h for the flow area.
  • Including the free surface.

Assumptions and limits

  • Uniform cross-section.

References

  • D_h = 4A/P (Textbook fluid mechanics (White, Fluid Mechanics))

Questions and answers

A 400 × 200 mm duct?

D_h = 4 × 0.08 / 1.2 = 267 mm.

An annulus?

D − d.

Is it the same as the equivalent diameter for duct sizing?

No: the duct-sizing equivalent diameter keeps the same pressure drop for the same flow; D_h is for Reynolds number and friction.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.