FireCADCalc

Iron and Copper Transport to the Boiler

Corrosion products carried into a boiler per hour and per year from their feedwater concentration and flow: the source of tube deposits.

Thermal power plantProcess steam and utilitiesSugar mill and cogenerationDistillery and ethanolBoiler

Inputs

Examples: 10 ppb at 100 t/hCopper 2 ppb

Results

This is the mass carried into the boiler. Most of it deposits, mainly on the hottest tubes, and part leaves with the blowdown; compare with deposit weight density from tube samples.

Transport rate0.12000g/h
Transported per year0.96000kg

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 10 ppb at 100 t/h. The inputs, in the units selected above:

InputValue
Iron (or copper) in feedwater10.000 ppb
Feedwater flow100.00 t/h
Operating hours per year7,500.0 h

Applying the formula below gives:

ResultValue
Transport rate1.0000 g/h
Transported per year7.5000 kg

Open this example in the calculator and change any input.

Formula

\(\dot m_{Fe} = c\,\dot m, \quad M_a = \dot m_{Fe} t\)

Variables

Symbol Meaning SI unit
\(c\) Iron (or copper) in feedwater -
\(\dot m\) Feedwater flow kg/s
\(t\) Operating hours per year s
\(\dot m_{Fe}\) Transport rate kg/s
\(M_a\) Transported per year kg

Method and standards

Mass balance.

Where it is used

  • Chemistry KPIs.
  • Chemical cleaning planning.

Common mistakes

  • ppm entered as ppb.

Assumptions and limits

  • Average concentration. The result is the mass transported, not the mass deposited; operating hours are limited to one year (8784 h at most).

References

  • Mass balance: rate = concentration × flow

Questions and answers

Why do a few ppb matter?

At 100 t/h, 10 ppb of iron carries about 7.5 kg a year into the boiler; most of it deposits on the tubes and part leaves with the blowdown.

Where does it come from?

Corrosion in feedwater heaters, condensate lines and the deaerator.

Cure?

Better pH control (amines), oxygen control and condensate polishing.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.