Worked example
Example: HP heater 12 bar(a). The inputs, in the units selected above:
| Input | Value |
|---|---|
| Shell (extraction steam) pressure (absolute) | 12.000 bar |
| Feedwater in | 140.00 °C |
| Feedwater out | 185.00 °C |
| Drain leaving | 148.00 °C |
Applying the formula below gives:
| Result | Value |
|---|---|
| Saturation temperature at shell pressure | 187.96 °C |
| Terminal temperature difference T_sat − T_fw,out | 2.9646 K |
| Drain cooler approach T_d − T_fw,in | 8.0000 K |
| Feedwater temperature rise | 45.000 K |
Open this example in the calculator and change any input.
Formula
\(TTD = T_{sat}(p_s) - T_{fw,out}, \quad DCA = T_d - T_{fw,in}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(p_s\) | Shell (extraction steam) pressure (absolute) | Pa |
| \(T_{fw,in}\) | Feedwater in | K |
| \(T_{fw,out}\) | Feedwater out | K |
| \(T_d\) | Drain leaving | K |
| \(T_{sat}\) | Saturation temperature at shell pressure | K |
| \(TTD\) | Terminal temperature difference T_sat − T_fw,out | K |
| \(DCA\) | Drain cooler approach T_d − T_fw,in | K |
| \(\Delta T\) | Feedwater temperature rise | K |
Method and standards
Definitions.
Where it is used
- Heater performance monitoring.
- BOE examinations.
Common mistakes
- Gauge pressure for T_sat.
- Confusing TTD and DCA.
Assumptions and limits
- Steady operation.
- A negative TTD is possible with a desuperheating zone. A negative DCA, or a drain hotter than saturation, is not physical; notes flag both.
References
- TTD = T_sat(p_shell) − T_fw
- out; DCA = T_drain − T_fw
- in (definitions as in the HEI Standards for Closed Feedwater Heaters and ASME PTC 12.1, Closed Feedwater Heaters); T_sat from IAPWS-IF97
Questions and answers
12 bar(a) shell, feedwater 140 → 185 °C, drain 148 °C?
T_sat about 188 °C: TTD about 3 K, DCA 8 K, rise 45 K.
Negative TTD?
Possible with a desuperheating zone: the outlet can exceed T_sat.
High DCA?
Often a low drain level letting steam through the drain cooler.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.