FireCADCalc

Air Heater Cold-End Average Temperature vs Acid Dew Point

Cold-end average temperature of an air preheater from gas exit and air inlet temperatures and its margin over the acid dew point, to judge cold-end corrosion risk.

Thermal power plantProcess steam and utilitiesSugar mill and cogenerationDistillery and ethanolEconomiser and air preheater

Inputs

Examples: Coal, 120 °C dew pointWinter air

Results

CEAT below the acid dew point: expect cold-end corrosion; use a steam coil air heater or air bypass.

Cold-end average temperature72.500°C
Margin over the dew point-42.500K

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Coal, 120 °C dew point. The inputs, in the units selected above:

InputValue
Gas out (corrected for leakage)140.00 °C
Air in30.000 °C
Acid dew point120.00 °C

Applying the formula below gives:

ResultValue
Cold-end average temperature85.000 °C
Margin over the dew point-35.000 K

Open this example in the calculator and change any input.

Formula

\(CEAT = \frac{T_{g,out} + T_{a,in}}{2}, \quad \Delta T = CEAT - T_{dp}\)

Variables

Symbol Meaning SI unit
\(T_{g,out}\) Gas out (corrected for leakage) K
\(T_{a,in}\) Air in K
\(T_{dp}\) Acid dew point K
\(CEAT\) Cold-end average temperature K
\(\Delta T\) Margin over the dew point K

Method and standards

The cold-end average temperature is the mean of the leakage-corrected gas outlet and air inlet temperatures, a common proxy for the lowest metal temperature. Here it is compared with the acid dew point. Air heater makers usually specify a minimum CEAT that depends on the fuel sulphur and the heater type; use that limit where you have it.

Where it is used

  • Air heater operation.
  • Low-load and winter operation.

Common mistakes

  • Leakage-diluted gas temperature used.

Assumptions and limits

  • Simple average; the gas must leave hotter than the air enters.
  • The margin flags corrosion only against the dew point, with a warning below 10 K (a FireCAD rule of thumb, not a maker's curve).

References

  • CEAT = (T_g,out + T_a,in)/2 (air heater practice); acid dew point from the acid-dew-point calculator

Questions and answers

Why the average?

It is a simple proxy for the lowest metal temperature at the cold end.

Biomass with little sulphur?

The water dew point and chlorides may govern instead of sulphuric acid.

How to raise CEAT in winter?

Steam coil air heaters or recirculating hot air.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.