FireCADCalc

True Stress and True Strain from Engineering Values

True stress and true (logarithmic) strain from engineering stress and strain up to necking, and the true fracture strain from the reduction of area.

Thermal power plantRefinery and petrochemicalChemical and fertiliser

Inputs

Examples: 400 MPa at 10 % strain, RA 60 %650 MPa at 20 %, RA 45 %250 MPa at 2 %, RA 70 %

Results

The conversions assume constant volume and uniform strain, so they hold only up to the ultimate tensile strength (start of necking).

True stress780.00MPa
True strain18.232%
True fracture strain ln(1/(1 − RA))59.784%

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 400 MPa at 10 % strain, RA 60 %. The inputs, in the units selected above:

InputValue
Engineering stress400.00 MPa
Engineering strain10.000 %
Reduction of area at fracture60.000 %

Applying the formula below gives:

ResultValue
True stress440.00 MPa
True strain9.5310 %
True fracture strain ln(1/(1 − RA))91.629 %

Open this example in the calculator and change any input.

Formula

\(\sigma_t = \sigma_e (1 + \varepsilon_e), \quad \varepsilon_t = \ln(1 + \varepsilon_e)\)

\(\varepsilon_f = \ln\frac{1}{1 - RA}\)

Variables

Symbol Meaning SI unit
\(\sigma_e\) Engineering stress Pa
\(\varepsilon_e\) Engineering strain -
\(RA\) Reduction of area at fracture -
\(\sigma_t\) True stress Pa
\(\varepsilon_t\) True strain -
\(\varepsilon_f\) True fracture strain ln(1/(1 − RA)) -

Method and standards

With volume constant during plastic flow, the current area is A₀/(1 + ε_e); this holds until necking, after which only the reduction of area gives true strain.

Where it is used

  • Preparing flow curves for forming and FE models.
  • Teaching tensile testing.
  • Comparing ductility by true fracture strain.

Common mistakes

  • Using the formulas after necking.
  • Entering strain in per cent as a fraction.
  • Mixing engineering and true values in one curve.

Assumptions and limits

  • Uniform deformation, constant volume: valid only up to necking (the uniform elongation). Beyond it the conversion does not apply, although the input range allows larger strains.

References

  • Constant-volume plastic deformation (Dieter, Mechanical Metallurgy, ch. 8)

Questions and answers

What true stress matches 400 MPa at 10 % strain?

440 MPa; the true strain is ln 1.1 = 0.0953.

Why are they different?

Engineering values use the original area and length; true values use the current ones, which change as the bar stretches and thins.

What is the true fracture strain?

ln(A₀/A_f) from the reduction of area: 60 % gives 0.92.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.