Worked example
Example: Plate 1 500 x 12 mm, 6 m, steel. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Shape | Plate or flat bar (width × thickness) |
| Width, diameter, side, across flats or outside diameter | 1,500.0 mm |
| Thickness or wall (plate, flat, tube) | 12.000 mm |
| Length | 6.0000 m |
| Number of pieces | 1.0000 - |
| Density of the metal | 7,850.0 kg/m³ |
Applying the formula below gives:
| Result | Value |
|---|---|
| Cross-section area | 18,000 mm² |
| Weight per metre | 141.30 kg/m |
| Weight of one piece | 847.80 kg |
| Total weight | 847.80 kg |
Open this example in the calculator and change any input.
Formula
\(A = a b \ \text{(plate)}, \; \frac{\pi}{4} a^2 \ \text{(round)}, \; a^2 \ \text{(square)}, \; \frac{\sqrt3}{2} a^2 \ \text{(hex)}, \; \pi (a - b) b \ \text{(tube)}\)
\(m' = A \rho, \quad m = m' L, \quad m_{tot} = N m\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(\text{shape}\) | shape | - |
| \(a\) | width, diameter, side, across flats or outside diameter | m |
| \(b\) | thickness or wall | m |
| \(L\) | length | m |
| \(N\) | number of pieces | - |
| \(\rho\) | density | kg/m³ |
| \(A\) | cross-section area | m² |
| \(m'\) | weight per metre | kg/m |
| \(m\) | weight of one piece | kg |
| \(m_{tot}\) | total weight | kg |
Method and standards
Weight is section area times density times length; the hexagon area across flats a is (√3/2) a².
Where it is used
- Estimating steel quantities and transport loads.
- Checking material take-offs.
- Pricing bar stock.
Common mistakes
- Using across corners instead of across flats for hex bar.
- Forgetting the quantity.
- Using steel density for aluminium.
Assumptions and limits
- Nominal dimensions; tolerances and corner radii ignored.
References
- Section geometry × density
Questions and answers
How heavy is a 1 500 × 12 mm steel plate 6 m long?
About 848 kg (141 kg per metre at 7 850 kg/m³).
What is the weight of a 50 mm round bar?
15.4 kg per metre in carbon steel.
What density should I use?
About 7 850 kg/m³ for carbon steel, 7 900–8 000 for stainless and 2 700 for aluminium; take the exact value from the material standard.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.