FireCADCalc

Seed (Slurry) Quantity for a Target Crystal Size

Seed crystal mass and slurry volume to grow a strike's crystal mass to a target mean size from a seed size, by the crystal number balance, and the crystal count.

Sugar mill and cogeneration

Inputs

Examples: 30 t crystal, 0.6 mm from 6 umRefined sugar 0.45 mm

A typical value for sugar crystals; use your own if measured. It affects the crystal count only.

Results

Assumes every seed crystal grows and no new grain forms; in practice adjust for dissolution, conglomerates and false grain.

Seed crystal mass112.37g
Seed slurry volume0.37458L
Crystals (millions)184,281

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 30 t crystal, 0.6 mm from 6 um. The inputs, in the units selected above:

InputValue
Crystal mass to produce per strike30.000 t
Target mean crystal size0.60000 mm
Seed crystal size6.0000 µm
Crystal content of the seed slurry250.00 g/L
Sucrose crystal density1,588.0 kg/m³
Volume shape factor0.75000 -

Applying the formula below gives:

ResultValue
Seed crystal mass30.000 g
Seed slurry volume0.12000 L
Crystals (millions)116,615

Open this example in the calculator and change any input.

Formula

\(m_s = M_c\left(\frac{L_s}{L_f}\right)^3, \quad N = \frac{M_c}{\rho_c k_v L_f^3}\)

Variables

Symbol Meaning SI unit
\(M_c\) Crystal mass to produce per strike kg
\(L_f\) Target mean crystal size m
\(L_s\) Seed crystal size m
\(c\) Crystal content of the seed slurry kg/m³
\(\rho_c\) Sucrose crystal density kg/m³
\(k_v\) Volume shape factor -
\(m_s\) Seed crystal mass kg
\(V_s\) Seed slurry volume m³
\(N\) Crystals (millions) -

Method and standards

Crystal number balance.

Where it is used

  • Pan seeding procedure.
  • Crystal size control.

Common mistakes

  • Seed size in µm entered as mm.

Assumptions and limits

  • All seed grows; no new nuclei. Seed dissolution, conglomerates and the size distribution (mean against mass-mean size) are ignored: in practice more seed is needed.
  • The defaults for crystal density (1 588 kg/m³) and shape factor (0.75) are typical values, not from a cited source; enter your own where known.

References

  • Crystal number balance: same number of crystals
  • mass ∝ L³ (shape factor cancels for the seed mass) (Rein, Cane Sugar Engineering, pan boiling)

Questions and answers

Why so little seed?

Mass grows with the cube of size: growing 100-fold in size multiplies mass a million times.

Full seeding?

Enough seed crystals to give every final crystal its own seed, rather than shock seeding and false grain.

Seed slurry?

Milled sugar in alcohol or saturated syrup; enter its crystal content.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.