FireCADCalc

Ethanol–Water Minimum Stages at Total Reflux

Minimum theoretical stages to go from a bottoms to a distillate strength at total reflux by stepping on the ethanol–water curve (Fenske with variable volatility).

Distillery and ethanolIAPWS-IF97 (water and steam)

Inputs

Examples: 94 % vol from 0.1 % vol80 % vol from 1 % vol

Model fitted at 1 atm; use 0.9–1.2 atm.

Results

Distillate mole fraction52.003%
Bottoms mole fraction0.31115%
Minimum stages (reboiler = 1)2.9133

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 94 % vol from 0.1 % vol. The inputs, in the units selected above:

InputValue
Distillate strength94.000 %
Bottoms strength0.10000 %
Pressure101.33 kPa

Applying the formula below gives:

ResultValue
Distillate mole fraction79.830 %
Bottoms mole fraction0.030938 %
Minimum stages (reboiler = 1)7.6104

Open this example in the calculator and change any input.

Formula

\(y_{n+1} = x_n, \quad x_n = x^*(y_n)\)

Variables

Symbol Meaning SI unit
\(q_D\) Distillate strength -
\(q_B\) Bottoms strength -
\(P\) Pressure Pa
\(x_D\) Distillate mole fraction -
\(x_B\) Bottoms mole fraction -
\(N_{min}\) Minimum stages (reboiler = 1) -

Method and standards

Stepping between the equilibrium curve and the diagonal.

Where it is used

  • Short-cut column design.
  • Checking existing columns.

Common mistakes

  • Using a mean α.
  • Specifying a distillate above the azeotrope.

Assumptions and limits

  • Wilson energies fitted at 1 atm; 0.9–1.2 atm only.
  • Binary ethanol–water; congeners and dissolved solids ignored.
  • Near the azeotrope (above about 94 % vol) N_min depends strongly on the accuracy of the fitted curve there; a note says so.

References

  • Ethanol–water VLE at about 1 atm: Wilson equation (Perry's Chemical Engineers' Handbook, 9th ed., sec. 4) with energies 399 and 933 cal/mol fitted to FireCAD ethanol–water x–y–T data at 101.325 kPa; ethanol vapour pressure Perry's 9th ed. Table 2-8; water IAPWS-IF97
  • Checked against Gmehling and Onken
  • DECHEMA Chemistry Data Series vol. I/1
  • as quoted in Perry's 9th ed. sec. 13 (simple batch distillation example)
  • Total reflux: operating line on the diagonal (Perry's 9th ed. sec. 13, Fig. 13-25)

Questions and answers

Why not use the Fenske equation?

Ethanol–water's relative volatility falls from about 10 to 1 across the column, so a single α is meaningless.

Why does 94 % vol need so many stages?

Near the azeotrope each stage gains very little.

Is this the actual stage count?

No, it is the minimum at infinite reflux; use the McCabe–Thiele calculator for a real reflux.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.