Worked example
Example: 100 t/h beer at 32 °C, stillage 105 °C. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Beer flow | 100.00 t/h |
| Beer specific heat | 4.0000 kJ/(kg·K) |
| Beer in | 32.000 °C |
| Stillage flow | 90.000 t/h |
| Stillage specific heat | 4.0500 kJ/(kg·K) |
| Stillage in | 105.00 °C |
| Approach: stillage out minus beer in | 10.000 K |
Applying the formula below gives:
| Result | Value |
|---|---|
| Heat recovered | 6,378.8 kW |
| Stillage out | 42.000 °C |
| Beer out | 89.409 °C |
| Log-mean temperature difference | 12.589 K |
Open this example in the calculator and change any input.
Formula
\(T_{s,out} = T_{b,in} + \Delta T_{ap}, \quad Q = \dot m_s c_s (T_{s,in} - T_{s,out}), \quad T_{b,out} = T_{b,in} + \frac{Q}{\dot m_b c_b}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(\dot m_b\) | Beer flow | kg/s |
| \(c_b\) | Beer specific heat | J/(kg·K) |
| \(T_{b,in}\) | Beer in | K |
| \(\dot m_s\) | Stillage flow | kg/s |
| \(c_s\) | Stillage specific heat | J/(kg·K) |
| \(T_{s,in}\) | Stillage in | K |
| \(\Delta T_{ap}\) | Approach: stillage out minus beer in | K |
| \(Q\) | Heat recovered | W |
| \(T_{s,out}\) | Stillage out | K |
| \(T_{b,out}\) | Beer out | K |
| \(\Delta T_{lm}\) | Log-mean temperature difference | K |
Method and standards
Heat balance with a cold-end approach.
Where it is used
- Distillery heat integration.
- Steam saving studies.
Common mistakes
- Ignoring fouling margin.
- Using water specific heats for stillage.
Assumptions and limits
- No phase change; no losses.
- The cold-end approach is imposed. When the beer is the smaller capacity stream the hot end pinches first; a note appears when the hot-end difference falls below 5 K.
References
- Counter-flow heat balance and log-mean temperature difference (definitions)
Questions and answers
Why preheat the beer?
Beer fed near its boiling point cuts the beer column steam by roughly a third.
Why fix the cold-end approach?
With stillage flow close to beer flow, the cold end usually pinches.
What fouls?
Stillage solids and proteins; spiral or wide-gap plates resist it.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.