FireCADCalc

Thermal Shock Resistance Parameters of a Brittle Material

Critical quench temperature difference R and heat-flow parameter R′ of a brittle material from strength, modulus, expansion and conductivity.

Thermal power plantProcess steam and utilitiesSugar mill and cogenerationRefinery and petrochemicalChemical and fertiliserPulp and paper

Inputs

Examples: Dense aluminaSilicon carbide

Results

R is the ΔT that cracks a fully constrained surface on an instant quench (infinite Biot number); R′ governs at moderate heat transfer. Materials with low expansion and high conductivity (silicon carbide, silica glass) resist shock best.

Critical quench ΔT (parameter R)202.44K
Heat-flow parameter R′ = kR24,293W/m

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Dense alumina. The inputs, in the units selected above:

InputValue
Fracture (flexural) strength300.00 MPa
Poisson's ratio0.22000 -
Elastic modulus300.00 GPa
Thermal expansion coefficient8.0000 µm/(m·K)
Thermal conductivity20.000 W/(m·K)

Applying the formula below gives:

ResultValue
Critical quench ΔT (parameter R)97.500 K
Heat-flow parameter R′ = kR1,950.0 W/m

Open this example in the calculator and change any input.

Formula

\(R = \frac{\sigma_f(1 - \nu)}{E\alpha}, \quad R' = kR\)

Variables

Symbol Meaning SI unit
\(\sigma_f\) Fracture (flexural) strength Pa
\(\nu\) Poisson's ratio -
\(E\) Elastic modulus Pa
\(\alpha\) Thermal expansion coefficient 1/K
\(k\) Thermal conductivity W/(m·K)
\(R\) Critical quench ΔT (parameter R) K
\(R'\) Heat-flow parameter R′ = kR W/m

Method and standards

Kingery's parameters.

Where it is used

  • Refractory and ceramic selection.
  • Sight glasses and burner tiles.

Common mistakes

  • Comparing R across different heat transfer regimes.
  • Using compressive instead of tensile strength.

Assumptions and limits

  • Linear elastic, brittle.

References

  • Kingery (1955) thermal stress resistance parameters R = σ_f(1 − ν)/(Eα)
  • R′ = kR

Questions and answers

Why does conductivity help?

Heat spreads quickly, so surface and core temperatures stay closer and thermal stress is smaller.

Is R the actual ΔT a part survives?

It is the worst case (sudden quench); real parts with finite heat transfer survive larger ΔT.

What do the defaults represent?

A dense alumina-type ceramic.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.