Worked example
Example: Iron powder compact. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Compact mass | 21.500 g |
| Compact diameter | 15.000 mm |
| Compact height | 18.500 mm |
| Full (theoretical) density | 7,870.0 kg/m³ |
Applying the formula below gives:
| Result | Value |
|---|---|
| Green density | 6,576.5 kg/m³ |
| Relative density | 83.564 % |
| Porosity | 16.436 % |
Open this example in the calculator and change any input.
Formula
\(\rho_g = \frac{m}{\pi D^2 H/4}, \quad \varepsilon = 1 - \frac{\rho_g}{\rho_t}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(m\) | Compact mass | kg |
| \(D\) | Compact diameter | m |
| \(H\) | Compact height | m |
| \(\rho_t\) | Full (theoretical) density | kg/m³ |
| \(\rho_g\) | Green density | kg/m³ |
| \(\rho_g/\rho_t\) | Relative density | - |
| \(\varepsilon\) | Porosity | - |
Method and standards
Definitions.
Where it is used
- PM parts and bushes.
- Ceramic and refractory pressing.
Common mistakes
- Mass in g with volume in m³.
- Hollow parts as solid cylinders.
Assumptions and limits
- Solid cylinder.
References
- Density = mass/volume of a cylinder; porosity = 1 − ρ/ρ_t
Questions and answers
21.5 g in a 15 mm × 18.5 mm cylinder of iron powder?
Green density about 6576 kg/m³: 84 % of full.
Typical values?
Pressed iron parts are often 85–90 % dense.
Why measure?
Density controls strength and sintering shrinkage.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.