FireCADCalc

Steady-State Creep Rate (Norton Power Law)

Secondary creep rate of a metal at temperature and stress by Norton's power law with Arrhenius temperature dependence, with your constants and the time to a strain.

Inputs

Examples: Default constants at 550 °CHotter and lower stress

Fitted with the rate in 1/s and stress in MPa; from creep data for the material. The default set is illustrative, not a particular steel.

Results

Steady (secondary) creep only; primary and tertiary creep and rupture need their own data (see Larson–Miller).

Creep rate12.7221/h
Time to the strain (steady stage)7.8607e-04h

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Default constants at 550 °C. The inputs, in the units selected above:

InputValue
Constant A (1/s per MPa^n)1.0000e+07 -
Stress80.000 MPa
Stress exponent5.0000 -
Activation energy300.00 kJ/mol
Temperature550.00 °C
Creep strain of interest1.0000 %

Applying the formula below gives:

ResultValue
Creep rate10.840 1/h
Time to the strain (steady stage)9.2253e-04 h

Open this example in the calculator and change any input.

Formula

\(\dot\varepsilon = A\sigma^n \exp\left(-\frac{Q}{RT}\right)\)

Variables

Symbol Meaning SI unit
\(A\) Constant A (rate in 1/s with σ in MPa) -
\(\sigma\) Stress Pa
\(n\) Stress exponent -
\(Q\) Activation energy J/mol
\(T\) Temperature K
\(\varepsilon_t\) Creep strain of interest -
\(\dot\varepsilon\) Creep rate 1/s
\(t\) Time to the strain (steady stage) s

Method and standards

Norton–Arrhenius.

Where it is used

  • High-temperature components.
  • Creep testing analysis.

Common mistakes

  • Constants fitted in different stress units.
  • Extrapolating far beyond the data.

Assumptions and limits

  • Secondary creep.
  • A is a plain number fitted with the rate in 1/s and the stress in MPa; constants fitted in other units must be converted first.
  • The default constants are illustrative only; they give a rate of the order of 1 % in 100 000 h at 80 MPa and 550 °C.

References

  • Norton (1929) power law with Arrhenius term ε̇ = A σⁿ e^(−Q/RT)

Questions and answers

The default constants at 80 MPa and 550 °C?

About 1.08 × 10⁻⁷ per hour, so 1 % strain takes about 92 000 h. The default constants are illustrative, not a particular steel; use fitted data for design.

Why does temperature matter so much?

The exponential term: a few tens of degrees can change the rate tenfold.

Boiler tubes?

Use the material's creep rupture data for life; Norton describes deformation.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.