FireCADCalc

Elastic Constants: E, G, K and Poisson's Ratio

Shear modulus, bulk modulus and Lamé constant of an isotropic material from Young's modulus and Poisson's ratio, or Poisson's ratio from E and G.

Inputs

Examples: Steel E and nuAluminium E and G

Results

Poisson's ratio0.30000
Shear modulus76.923GPa
Bulk modulus166.67GPa
Lamé's first parameter115.38GPa

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Steel E and nu. The inputs, in the units selected above:

InputValue
Values givenE and ν
Young's modulus200.00 GPa
Poisson's ratio0.30000 -
Shear modulus77.000 GPa

Applying the formula below gives:

ResultValue
Poisson's ratio0.30000
Shear modulus76.923 GPa
Bulk modulus166.67 GPa
Lamé's first parameter115.38 GPa

Open this example in the calculator and change any input.

Formula

\(G = \frac{E}{2(1 + \nu)}, \quad K = \frac{E}{3(1 - 2\nu)}, \quad \lambda = \frac{E\nu}{(1 + \nu)(1 - 2\nu)}\)

Variables

Symbol Meaning SI unit
\(\text{given}\) Values given -
\(E\) Young's modulus Pa
\(\nu\) Poisson's ratio -
\(G\) Shear modulus Pa
\(K\) Bulk modulus Pa
\(\lambda\) Lamé's first parameter Pa

Method and standards

Isotropic elasticity.

Where it is used

  • Shaft torsion and spring design.
  • FEA input.

Common mistakes

  • Using these for anisotropic materials.
  • ν outside −1 to 0.5.

Assumptions and limits

  • Isotropic, linear elastic.

References

  • Isotropic elasticity G = E/(2(1 + ν))
  • K = E/(3(1 − 2ν))
  • λ = Eν/((1 + ν)(1 − 2ν))

Questions and answers

Steel, E 200 GPa, ν 0.3?

G 76.9 GPa, K 166.7 GPa.

ν near 0.5?

Nearly incompressible (rubber): K becomes very large.

Anisotropic materials?

Composites and wood need direction-dependent constants.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.