Worked example
Example: Steel E and nu. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Values given | E and ν |
| Young's modulus | 200.00 GPa |
| Poisson's ratio | 0.30000 - |
| Shear modulus | 77.000 GPa |
Applying the formula below gives:
| Result | Value |
|---|---|
| Poisson's ratio | 0.30000 |
| Shear modulus | 76.923 GPa |
| Bulk modulus | 166.67 GPa |
| Lamé's first parameter | 115.38 GPa |
Open this example in the calculator and change any input.
Formula
\(G = \frac{E}{2(1 + \nu)}, \quad K = \frac{E}{3(1 - 2\nu)}, \quad \lambda = \frac{E\nu}{(1 + \nu)(1 - 2\nu)}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(\text{given}\) | Values given | - |
| \(E\) | Young's modulus | Pa |
| \(\nu\) | Poisson's ratio | - |
| \(G\) | Shear modulus | Pa |
| \(K\) | Bulk modulus | Pa |
| \(\lambda\) | Lamé's first parameter | Pa |
Method and standards
Isotropic elasticity.
Where it is used
- Shaft torsion and spring design.
- FEA input.
Common mistakes
- Using these for anisotropic materials.
- ν outside −1 to 0.5.
Assumptions and limits
- Isotropic, linear elastic.
References
- Isotropic elasticity G = E/(2(1 + ν))
- K = E/(3(1 − 2ν))
- λ = Eν/((1 + ν)(1 − 2ν))
Questions and answers
Steel, E 200 GPa, ν 0.3?
G 76.9 GPa, K 166.7 GPa.
ν near 0.5?
Nearly incompressible (rubber): K becomes very large.
Anisotropic materials?
Composites and wood need direction-dependent constants.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.