FireCADCalc

ASTM Grain Size Number ↔ Grains per mm² and Grain Size

Convert an ASTM E112 grain size number to grains per square millimetre and a mean grain diameter, or the reverse, for use with Hall–Petch.

Inputs

Examples: G = 81000 grains per mm2Coarse G = 3

Results

The mean diameter here is the square root of the mean grain area, one of several conventions.

Grain size number8.0000
Grains per mm² at 1×1,984.0
Grains per square inch at 100×128.00
Mean grain diameter 1/√N_A22.451µm

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: G = 8. The inputs, in the units selected above:

InputValue
Value givenASTM grain size number G
ASTM grain size number8.0000 -
Grains per mm² at 1×1,984.0 -

Applying the formula below gives:

ResultValue
Grain size number8.0000
Grains per mm² at 1×1,984.0
Grains per square inch at 100×128.00
Mean grain diameter 1/√N_A22.451 µm

Open this example in the calculator and change any input.

Formula

\(N_{100} = 2^{G-1}, \quad N_A = 15.50 \times 2^{G-1}, \quad \bar d = \frac{1}{\sqrt{N_A}}\)

Variables

Symbol Meaning SI unit
\(\text{given}\) Value given -
\(G\) ASTM grain size number -
\(N_A\) Grains per mm² at 1× -
\(N_{100}\) Grains per square inch at 100× -
\(\bar d\) Mean grain diameter 1/√N_A m

Method and standards

ASTM E112 definition.

Where it is used

  • Metallography reports.
  • Weld and heat treatment checks.

Common mistakes

  • Magnification mixed up.
  • Different diameter conventions.

Assumptions and limits

  • Equiaxed grains.
  • The mean diameter is 1/√N_A (about 22.5 µm at G 8); the ASTM E112 mean lineal intercept is smaller (about 20 µm at G 8). Use the convention your Hall–Petch data were fitted with.

References

  • ASTM E112 definition N = 2^(G−1) grains per in² at 100×; ×15.50 for grains per mm² at 1×

Questions and answers

G = 8?

About 1984 grains per mm², mean size about 22.5 µm.

Larger G?

Finer grains: each step halves the grain area.

Which diameter for Hall–Petch?

Use the convention your data were fitted with.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.