FireCADCalc

Time of Concentration by the Kirpich Formula

Time of concentration of a small catchment from the flow path length and average slope by the Kirpich (1940) formula, for use with the rational method.

Inputs

Examples: 800 m falling 12 mPaved yard 200 m falling 1 mHill catchment 3 km falling 150 m

1 for natural ground; local manuals reduce it for paved or concrete channels (for example 0.2–0.4).

Results

Kirpich's data came from small rural catchments (under about 80 ha) in Tennessee; it is widely used beyond them with care.

Average slope ΔH/L0.50000%
Time of concentration3.5412min

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 800 m falling 12 m. The inputs, in the units selected above:

InputValue
Longest flow path800.00 m
Fall along the flow path12.000 m
Surface adjustment factor1.0000 -

Applying the formula below gives:

ResultValue
Average slope ΔH/L1.5000 %
Time of concentration16.865 min

Open this example in the calculator and change any input.

Formula

\(t_c = 0.0078\, k\, L_{ft}^{0.77}\, S^{-0.385} \ \text{min}, \quad S = \frac{\Delta H}{L}\)

Variables

Symbol Meaning SI unit
\(L\) Longest flow path m
\(\Delta H\) Fall along the flow path m
\(k\) Surface adjustment factor -
\(S\) Average slope ΔH/L -
\(t_c\) Time of concentration s

Method and standards

Empirical.

Where it is used

  • Plant drainage and storm water design.
  • Ash pond and coal yard runoff.

Common mistakes

  • L in metres in the feet formula.
  • Using it for large catchments.

Assumptions and limits

  • Small catchments.

References

  • Kirpich
  • Z. P. (1940)
  • Time of concentration of small agricultural watersheds
  • Civil Engineering 10(6): t_c = 0.0078 L^0.77 S^−0.385 (minutes, L in feet)

Questions and answers

800 m flow path falling 12 m?

Slope 1.5 %: t_c about 16.9 minutes.

Why does tc matter?

The rational method uses the rainfall intensity for a storm lasting tc.

Metric form?

t_c = 0.0195 L0.77 S−0.385 with L in metres; it is the same formula.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.