Worked example
Example: 0.15 m³/s average, pumped 16 h/day. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Flow | 540.00 m³/h |
| Lea coefficient (0.97–1.22) | 1.1000 - |
| Pumping hours per day | 16.000 h |
Applying the formula below gives:
| Result | Value |
|---|---|
| Lea economic diameter | 426.03 mm |
| Velocity at D_Lea on the average flow Q | 1.0523 m/s |
| Diameter for the pumping hours | 557.20 mm |
| Velocity at D_λ (on peak flow 24Q/t) | 0.92272 m/s |
Open this example in the calculator and change any input.
Formula
\(D = k\sqrt Q, \quad D = 1.3\lambda^{1/4}\sqrt{Q_p},\ \lambda = \frac{t}{24}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(Q\) | Flow | m³/s |
| \(k\) | Lea coefficient (0.97–1.22) | - |
| \(t\) | Pumping hours per day | s |
| \(D_{Lea}\) | Lea economic diameter | m |
| \(v_{Lea}\) | Velocity at D_Lea on the average flow Q | m/s |
| \(D_\lambda\) | Diameter for the pumping hours | m |
| \(v_\lambda\) | Velocity at D_λ (on peak flow 24Q/t) | m/s |
Method and standards
Economic diameter rules.
Where it is used
- Raw-water and make-up water mains.
- Effluent rising mains.
Common mistakes
- Using peak flow in Lea's formula.
- Ignoring surge in the final choice.
Assumptions and limits
- Rule-of-thumb economics.
- Lea's formula is applied to the average daily flow Q; the velocity shown for it is on Q, and the note gives the higher running velocity on 24Q/t. Which flow Lea's k was fitted to is not stated in the source, so treat D_Lea as indicative.
References
- Lea's formula D = k√Q; D = 1.3λ^¼√Q for pumping λ = t/24 of the day (CPHEEO Manual on Water Supply and Treatment, ch. 6)
Questions and answers
Why is there an economic diameter?
Larger pipes cost more to buy but less to pump through; the total annual cost has a minimum.
Why does pumping time matter?
Pumping for fewer hours means a higher flow rate while running, so a larger pipe.
What do the defaults represent?
A 0.15 m³/s average flow pumped 16 hours a day.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.