FireCADCalc

Adiabatic Compression Temperature (Ignition Check)

Gas temperature after rapid adiabatic compression to a final pressure, compared with an autoignition temperature (oxygen valves, air in hoses).

Thermal power plantRefinery and petrochemicalChemical and fertiliserPulp and paperFood, dairy and textile

Inputs

Examples: Air 20 °C, 1 to 200 barOxygen 25 °C, 1 to 10 bar

Results

The compression temperature reaches the autoignition temperature: slow the valve opening or change materials.

Screening estimate only, not a safety study or a basis for protective design.

Temperature after compression1,053.9°C
Margin to autoignition-703.92K

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Air 20 °C, 1 to 200 bar. The inputs, in the units selected above:

InputValue
Initial temperature20.000 °C
Initial pressure (absolute)1.0132 bar
Final pressure (absolute)200.00 bar
Ratio of specific heats1.4000 -
Autoignition temperature of the material at risk350.00 °C

Applying the formula below gives:

ResultValue
Temperature after compression1,053.9 °C
Margin to autoignition-703.92 K

Open this example in the calculator and change any input.

Formula

\(T_2 = T_1\left(\frac{p_2}{p_1}\right)^{(\gamma - 1)/\gamma}\)

Variables

Symbol Meaning SI unit
\(T_1\) Initial temperature K
\(p_1\) Initial pressure (absolute) Pa
\(p_2\) Final pressure (absolute) Pa
\(\gamma\) Ratio of specific heats -
\(T_{AIT}\) Autoignition temperature of the material at risk K
\(T_2\) Temperature after compression K
\(T_{AIT} - T_2\) Margin to autoignition K

Method and standards

Isentropic compression of the trapped gas, the textbook screening form. Oxygen-compatibility assessments (for example ASTM G74-type pneumatic impact tests) often model the rapid filling of a dead end differently, and the numbers differ; use this page as an indicator of the hazard, not as a substitute for those methods.

Where it is used

  • Oxygen system design.
  • Pneumatic and hydraulic safety reviews.

Common mistakes

  • Using gauge pressures.
  • Ignoring that seals ignite below metal.

Assumptions and limits

  • Ideal gas; no heat loss.

References

  • Isentropic compression of an ideal gas (definitions)

Questions and answers

Why can opening an oxygen valve start a fire?

Gas rushing into a dead-ended line is compressed almost adiabatically and can exceed the autoignition temperature of seals or contaminants.

What does 1 to 200 bar give?

Air from 20 °C reaches over 1,000 °C in theory.

Is the real temperature that high?

Heat loss lowers it, but the estimate shows the risk.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.