Worked example
Example: 2 in tube, R = 2D. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Tube outside diameter | 50.800 mm |
| Wall thickness before bending | 4.5000 mm |
| Bend centreline radius | 100.00 mm |
| Largest measured diameter | 52.500 mm |
| Smallest measured diameter | 49.500 mm |
Applying the formula below gives:
| Result | Value |
|---|---|
| Extrados (outside) thickness | 3.5885 mm |
| Intrados (inside) thickness | 6.0322 mm |
| Extrados thinning | 20.255 % |
| Ovality (D_max − D_min)/D | 5.9055 % |
Open this example in the calculator and change any input.
Formula
\(t_e = t_0\frac{R}{R + D/2}, \quad t_i = t_0\frac{R}{R - D/2}, \quad O = \frac{D_{max} - D_{min}}{D}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(D\) | Tube outside diameter | m |
| \(t_0\) | Wall thickness before bending | m |
| \(R\) | Bend centreline radius | m |
| \(D_{max}\) | Largest measured diameter | m |
| \(D_{min}\) | Smallest measured diameter | m |
| \(t_e\) | Extrados (outside) thickness | m |
| \(t_i\) | Intrados (inside) thickness | m |
| \(1 − t_e/t_0\) | Extrados thinning | - |
| \(O\) | Ovality (D_max − D_min)/D | - |
Method and standards
Constant-volume geometry: the wall at the extrados stretches, and at the intrados shortens, with the length of the fibre at R ± D/2 relative to the centreline, so the thickness changes in inverse proportion. Ovality is the difference of the measured diameters over the nominal diameter.
Where it is used
- Bend specification and inspection.
- Tube failure analysis.
Common mistakes
- Bend radius measured to the inside.
Assumptions and limits
- Constant volume, no axial feed; the wall thickness must be less than D/2.
- The outer fibre radius R + D/2 is used for the whole wall; the mid-wall radius would give slightly less thinning, and real bends with axial push thin less still. The code minimum thickness after bending is not checked.
References
- Constant-volume fibre-length geometry: t_e = t₀ R/(R + D/2)
- t_i = t₀ R/(R − D/2); ovality = (D_max − D_min)/D
Questions and answers
Why does the outside thin?
The outer fibre stretches as the tube bends, so its wall gets thinner.
Tight bends?
At R = 1.5 D the outer wall thins by about a quarter in this estimate.
Is this the code thickness?
No: codes give the minimum thickness after bending; use this to estimate what bending will do.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.