FireCADCalc

Pipe Thrust Force at a Bend or Expansion Joint

Resultant thrust on a pipe bend or an unrestrained expansion joint from internal pressure and flow momentum, for anchor and thrust block design.

Thermal power plantProcess steam and utilitiesRefinery and petrochemicalChemical and fertiliser

Inputs

Examples: 200 mm, 90° bend, 10 bar g, 50 L/s500 mm, 45°, 16 bar g, 400 L/sExpansion joint (straight), 150 mm, 6 bar g

Results

The resultant acts along the bisector of the bend, outwards. Use the test pressure for anchors that must survive the hydrotest.

Pressure thrust on one end p A (expansion joint)31.416kN
Momentum force on one end ρ Q v0.079418kN
Resultant on the bend 2 (pA + ρQv) sin(θ/2)44.541kN

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 200 mm, 90° bend, 10 bar g, 50 L/s. The inputs, in the units selected above:

InputValue
Internal pressure (gauge)10.000 bar
Inside diameter (or effective diameter of the bellows)200.00 mm
Bend angle (change of direction)90.000 °
Volume flow180.00 m³/h
Fluid density998.00 kg/m³

Applying the formula below gives:

ResultValue
Pressure thrust on one end p A (expansion joint)31.416 kN
Momentum force on one end ρ Q v0.079418 kN
Resultant on the bend 2 (pA + ρQv) sin(θ/2)44.541 kN

Open this example in the calculator and change any input.

Formula

\(F_p = pA, \quad F_m = \rho Q v, \quad F_R = 2(pA + \rho Q v)\sin\frac{\theta}{2}\)

Variables

Symbol Meaning SI unit
\(p\) Internal pressure (gauge) Pa
\(d\) Inside diameter (or effective diameter of the bellows) m
\(\theta\) Bend angle (change of direction) rad
\(Q\) Volume flow m³/s
\(\rho\) Fluid density kg/m³
\(F_p\) Pressure thrust on one end p A (expansion joint) N
\(F_m\) Momentum force on one end ρ Q v N
\(F_R\) Resultant on the bend 2 (pA + ρQv) sin(θ/2) N

Method and standards

Force balance on the bend control volume.

Where it is used

  • Thrust blocks for buried mains.
  • Anchors for expansion joints.

Common mistakes

  • Using outside diameter.
  • Forgetting test pressure.

Assumptions and limits

  • Equal inlet and outlet sizes.

References

  • Momentum equation on a pipe bend (Textbook fluid mechanics (White, Fluid Mechanics))

Questions and answers

A 200 mm, 90° bend at 10 bar g?

Pressure thrust 31.4 kN per end; resultant about 44.5 kN.

Why do expansion joints need anchors?

An unrestrained bellows pushes the pipe apart with p A.

Is momentum important?

Only at high velocity; pressure usually dominates.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.