Worked example
Example: 100 TCH, 14 % SO2. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Crushing rate | 100.00 t/h |
| Sulphur per tonne cane | 0.40000 kg/t |
| SO₂ in the gas (by volume) | 14.000 % |
| Tray loading | 22.500 kg/(m²·h) |
Applying the formula below gives:
| Result | Value |
|---|---|
| Sulphur burnt | 40.000 kg/h |
| Air | 199.75 Nm³/h |
| Air | 258.14 kg/h |
| Excess air | 49.643 % |
| Burner tray area | 1.7778 m² |
| Heat released (2217 kcal/kg S) | 103.13 kW |
Open this example in the calculator and change any input.
Formula
\(\dot m_S = d_S A, \quad \dot n_{air} = \frac{\dot m_S/M_S}{y_{SO_2}}, \quad \lambda - 1 = \frac{0.2095}{y_{SO_2}} - 1, \quad A_t = \frac{\dot m_S}{g}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(A\) | Crushing rate | kg/s |
| \(d_S\) | Sulphur per tonne cane | kg/kg |
| \(y_{SO_2}\) | SO₂ in the gas (by volume) | - |
| \(g\) | Tray loading | kg/(m²·s) |
| \(\dot m_S\) | Sulphur burnt | kg/s |
| \(\dot V_a\) | Air | Nm³/s |
| \(\dot m_a\) | Air | kg/s |
| \(\lambda - 1\) | Excess air | - |
| \(A_t\) | Burner tray area | m² |
| \(\dot Q\) | Heat released (2217 kcal/kg S) | W |
Method and standards
Stoichiometry of sulphur combustion.
Where it is used
- Sizing sulphur burners and compressors.
- Checking sulphitation gas strength.
Common mistakes
- Using SO₂ mass % for volume %.
- Confusing air at 0 °C with air at the compressor.
Assumptions and limits
- Complete combustion to SO₂; sublimed sulphur and burner efficiency are not included.
- Air is dry, in normal m³ at 0 °C and 1 atm, not air at the compressor conditions.
- The heat of combustion 2 217 kcal/kg S is used as a fixed figure on this page.
References
- Hugot
- Handbook of Cane Sugar Engineering
- 3rd ed. (Elsevier, 1986)
- ch. 25
- sulphur furnaces
- pp. 407–410
- Stoichiometry S + O₂ → SO₂; air O₂ 20.95 % by volume; molar volume at 0 °C
- 1 atm
Questions and answers
Why not burn with the theoretical air?
The gas would approach 21 % SO₂ and the furnace would overheat and sublime sulphur; 12–16 % is usual.
Why dry the air?
Moisture favours SO₃ and sulphuric acid, which corrode and waste sulphur.
Hugot's air figure?
About 6 m³ of air per kg of sulphur gives roughly 12 % SO₂.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.